Kapanadze Cousin - DALLY FREE ENERGY

[Hoppy]

Here is akula's approach:
The instruments based on https://en.wikipedia.org/wiki/Electrometer are good start for finding Tesla coil frequency timings and relation between how much of charges are being attracted into grenade. For a start akula suggested to place small foil near the top of Tesla coil. Then connect foil to the few picofarads capacitor then to the ground for substitute of grenade. Then start looking on the scope for BEMF like kicks on the capacitor and maximising them right after Tesla is getting switched off is the crucial for finding what voltage and frequency is required for the Tesla coil. Only after finding frequency of the kicks and creating their resonant condition for the constant current flow the grenade coil is made as receiver for this exact condition.
This is what still waiting to be tested when I will get time in the lab.

Cheers!

I have highlighted where T-1000 is reporting that Akula suggests that the grenade is made after the Tesla coil frequency has been determined by the 'kicks' method.

[John.K1]

Nick,

akula method is from other side. First he match Tesla coil frequency and voltage to the response of the ambient energy, then he build receiver (grenade coil) to siphon and charge bifilar coil on same parameters. The last bit is the induction series push-pull which is in sync with Tesla coil on low frequency resonant harmonic.

Hopefully that will clarify tuning method.

Cheers!

Hi Guys,

With all due respect, T-1000 ,but this is not What I see in Akulas video. If I good remember, he says he tunes his Bifilar coil to the ground first. This is why he shows how to measure the ground responds.

I tell you my point of view- the way I started to rebuild Ruslan's device:  We all agree that the coil has some length = Wave resonance. It has also inductance and capacitance=> LC resonance. Couple posts back I had posted very simple calculator , which can help you to design the coil in such  way that it should have LC and wave resonance "equal" .  Logicaly it should be tuned such way.  The only two things I have to figured out- one is- what frequency do I want to tune it to.  I measured the frequency with scope and it corresponds well with the method using mA meter. When I connect my coil to the ground, the resonance drops down by 200KHz. I think I will have to recalculate my coil for the "grounded" frequency.   The second thing is: does it really matter what  geometrical shape the coil has? We know for sure it is 1/4 resonator and the first layer is 1/4 of the lengh of the wire. It has been said the 5,6 just tune the inductance (to what you get in the calculator) And what about 3,4 layer? 

I think , we all are very close!

regards,

Jan

[T-1000]

Hi Guys,

With all due respect, T-1000 ,but this is not What I see in Akulas video. If I good remember, he says he tunes his Bifilar coil to the ground first. This is why he shows how to measure the ground responds.

I just did report what was told by himself in private Skype conversation.
It is your choice which way you will be going...

[NickZ]

   T-1000:
   Can you please indicate the video showing that method. However, it may work that way as well. And I'm sure that you understand the Russian language much better than I do.
  Please remember that this method applies mainly to the 2nd Akula device.
 
   The Ruslan way is much easier, and does not involve the same approach. And his output of 4000w is twice as strong as Akula's device.
 
   If you remember Itsu did not find Akula's method to work, at least for him. I don't remember now all the details, as it's been a while now since it was done.
   I do remember Itsu's explanation of the procedure, as I asked him specifically about it. As far as I believe, it was as I have just explained it. But, this thing about standing waves, is still not clear, nor well proven, and confusing, also.
  In any case it's good to recap, and to try to understand the process of heterodyning.
  Thanks for your reply.

[John.K1]

I just did report what was told by himself in private Skype conversation.
It is your choice which way you will be going...

  That means - do it opposite to what he says!! , the same as Ruslan now deny all what he said and shows before    It is like a code language- you will satisfy the one watching in shadows and help to others     

This man Rules!!  see Ruslan's comment below    https://www.youtube.com/watch?v=pNFXlo5jv4g