Kapanadze Cousin - DALLY FREE ENERGY

[T-1000]

   Yes, the socket IC holder would really help, I'll install it if I need to replace the TL 494 chip.

   I'm nearly ready to add the fet drivers, and snubbers, next. All to be installed on that single PCB. No long connection wires.

In addition to the board you are building you will need to regulate duty cycle (5-50%) for the positive and negative pulses individually. I would suggest to add 1 more chip with delay lines while you are still building it.

Cheers!

[Meta]

    *****
    Posts: 1198
        View Profile Personal Message (Offline)

Re: Kapanadze Cousin - DALLY FREE ENERGY
« Reply #16776 on: March 01, 2017, 02:57:08 AM »

    Quote

https://youtu.be/GiT0hPYSiss


Wesley

_________________________


I'm surprised no one noticed what happened when the metal shunt on the end of the stick, was shorted across the terminals next to one of the light bulbs. One would expect a shower of sparks, killing the whole machine and welding the shunt to the two terminals.......IF there was normal electricity lighting the bulbs.......

But why did the lights come on again and why didnt it short and why were there no sparks...

perhaps because the gas in the bulbs was being ionized and not the filiments?

perhaps because it was not normal electricity?

perhaps it was radiant RF being fed into the bulbs by the Tesla coil in parallel with the low primary and high secondary coil pairs?

perhaps Gerrard was right?

[Dog-One]

A simple answer, yes or no...

Does the wire length of layers 1 + 2 = 3 + 4 + 5 + 6?

[Acca]

 "But why did the lights come on again and why didn't it short and why were there no sparks...

perhaps because the gas in the bulbs was being ionized and not the filaments?

perhaps because it was not normal electricity?

perhaps it was radiant RF being fed into the bulbs by the Tesla coil in parallel with the low primary and high secondary coil pairs?"


YES...see clip... of " RF type high frequency electricity".https://www.youtube.com/watch?v=OGkZIx4rseE
Acca

[Utopia Now]

Hello Dog One    ..... Yess     2 times 19M is  38M

A simple answer, yes or no ...

Is the wire length of layers 1 + 2 = 3 + 4 + 5 + 6?