Kapanadze Cousin - DALLY FREE ENERGY

[itsu]

Nick,

i always understood that you should aim for resonance on the inductor, then adjust the kacher frequency to 50x, 60x or 100x that frequency.

Can you manipulate the kacher frequency, like by inserting a ferrite rod?


Itsu

[AlienGrey]

Nick,

i always understood that you should aim for resonance on the inductor, then adjust the kacher frequency to 50x, 60x or 100x that frequency.

Can you manipulate the kacher frequency, like by inserting a ferrite rod?


Itsu

I wouldn't have thought so, remember the V W wave form Enjoykin was excited about? Shurley, you haven't forgotten it's 3 times, come on figure it out you can do it  also have you seen  this video

https://www.youtube.com/watch?v=pWHEqx3Y5-w

Regards Allen

[itsu]

AG,

this 3 times relation you mention, is to my knowledge not about the resonance of the wima cap/inductor compared to the kacher frequency.

Its the relation of the resonance frequency of the Grenade compared to the kacher frequency.
Like in my setup where i had the Grenade resonating on 2665Khz (2.665MHz) and had the kacher tuned (via a ferrite rod) to 1/3th which was 888Khz.

Ontop of that realtionship, there also has to be a 50x, 60x or 100x relation between the wima cap/ inductor resonance frequency and Grenade resonance frequency 

My setup was tuned for:
2.665Mhz grenade resonance frequency
888Khz kacher frequency (1/3)
26.6Khz wima cap / inductor resonance frequency (1/100th)

See this video: https://www.youtube.com/watch?v=1Tgkg1XrDlk


At least that was how i understood the important relationships.

Itsu

[Void]

My setup was tuned for:
2.665Mhz grenade resonance frequency
888Khz kacher frequency (1/3)
26.6Khz wima cap / inductor resonance frequency (1/100th)
See this video: https://www.youtube.com/watch?v=1Tgkg1XrDlk
At least that was how i understood the important relationships.
Itsu

Hi Itsu. That was a good video. Was there any particular phase shift setting for firing the kacher
that made the load light bulb at all noticeably more brighter than other phase settings? For example, did you get
any better brightness on the bulbs when firing the kacher on the current peaks for the resonant loop?
Did you have an earth ground wire connected, and, if so, where was it connected to? I realize the video was from
Nov. 2015, so you may not remember all the details now.

[Utopia Now]

Hallo Itsu   and Nick    and others.

I want to dive into this device also   .. I find it very  inspiring  to read the info and  tips  and  guidance  that  you offer Itsu.

Can you post or link a, or the   schematic  that  is used  here .

I would like to start ordering parts  , mosfets caps ic`s etc. and than start soldering.

Thanks everybody

Utopia Now