Kapanadze Cousin - DALLY FREE ENERGY

[Hoppy]

Hoppy is that a joke or a cry of desperation ? read Magpowers last posting again, If you would pls.

Magpwr wrote: "I am no longer involved in this replication task." So in my opinion its fair to ask if he is working on any others.

[AlienGrey]

Magpwr wrote: "I am no longer involved in this replication task." So in my opinion its fair to ask if he is working on any others.

Good point, Magpower is a good man as others lets hope so, it least he is watching what going on.

AG

[magpwr]

Hi Mags,

Are you attempting to replicate any of the claimed self-runners?

Hello Hoppy,

No i am not doing anything in the area of OU after running out of luck on creativity.

Last best achieved was 10khz circuit operation but output 80khz "sine-wave" using parametric oscillator circuit using LM393 as front end to small toroid coil(sensor) in parallel with 10ohms only with with kacher activated but no OU.
Above circuit i was using divide by 3 counter (50% duty shown in my youtube:sanjev21) after hex inverter after LM393N.Derived from Akula circuit using frequency divider 4017 in block diagram.
But Geofusion demo revealed something very unusual for me at his "Kacher Antenna".

You might be already aware more turns at transformer or kacher/tesla coil would produce higher voltage but current would decrease.
For Geofusion case i was seeing orange spark at Antenna compared to the spark taken at top of tesla or kacher coil violet colour.

It's just too bad due to lack of proper measuring equipment for Geofusion is unable to reveal pwm frequency/duty cycle and frequency of tesla coil (probe at a distant).

Not to forget i was using IGBT(similar to Akula) driven at 15volts peak instead of MOSFET which is easy to be damaged.

So long story short due to insufficient further input i am unable to come up with anything new in my head or even perform a wave form generater freezed comparison related to pwm /kacher frequency from Geofusion.

[GeoFusion]

Hello Hoppy,

No i am not doing anything in the area of OU after running out of luck on creativity.

Last best achieved was 10khz circuit operation but output 80khz "sine-wave" using parametric oscillator circuit using LM393 as front end to small toroid coil(sensor) in parallel with 10ohms only with with kacher activated but no OU.
Above circuit i was using divide by 3 counter (50% duty shown in my youtube:sanjev21) after hex inverter after LM393N.Derived from Akula circuit using frequency divider 4017 in block diagram.
But Geofusion demo revealed something very unusual for me at his "Kacher Antenna".

You might be already aware more turns at transformer or kacher/tesla coil would produce higher voltage but current would decrease.
For Geofusion case i was seeing orange spark at Antenna compared to the spark taken at top of tesla or kacher coil violet colour.

It's just too bad due to lack of proper measuring equipment for Geofusion is unable to reveal pwm frequency/duty cycle and frequency of tesla coil (probe at a distant).

Not to forget i was using IGBT(similar to Akula) driven at 15volts peak instead of MOSFET which is easy to be damaged.

So long story short due to insufficient further input i am unable to come up with anything new in my head or even perform a wave form generater freezed comparison related to pwm /kacher frequency from Geofusion.

Hi magpwr,

Well, I do have the right measuring equips to see what the frequencies which things are and
even a probe if needed to see what happens to the field near the Antenna and grenade.

Btw, the Kacher, Yes without the ferrite choke and the antenna you can see the normal violet color,
But it's the whole configuration of how you connect the ferrite piece and the antenna, especially the direction! is very important
and the distance to the inductor wounded ontop of grenade. this brings amps in the high voltage end. even without the grenade it is
manageable to get those orange arcs. Has to do very less about how the freq should be and yet good amount of power pumped in,
duty cycle or so. but it's  all about the winding directions.
This was already done with simple kacher circuit, still on vidoes for view.
without that result I am unable to get the manifestation which was presented in lastest videos.
It show's how the Tesla coil/kacher is actualy calling upon the charges which that will be accelerated within the
induction pulsed inductor on grenade. Frequencies can differ everymoment, It was everytime on each setup different but
getting it to do that , there are methods.

lets say the last time it was working on bench, was reading 21khz pwm over toroid and about 880khz freq tesla coil antenna.
with the tapping points on the secondary of tesla coil, it changes values and might get better results on harmonics of it.
but I assure you, freq at some point is to overclock the energy coming in that is it, is part of how I see it and has something more to it.

I'll give you a tip, the series resonance does not have to be on point ( Top and best series resonance area with the 3T and cap)
for it to resonate with incoming charges from antenna,
this is where many don't understand and it was hard for me to figure this one out while doing  wicked experimentation.
It has sweet spots, Imagine the magnetic field bubble and how the antenna is sitting in it, and accelerate.
Nickz is close by doing this, he is hitting those sweet spots. where things get very fragile and even the hand creates capacitance.

cheers~

[stivep]

https://www.youtube.com/watch?v=5Nk1KLkfYfk
I have approached  them  some time ago.
In my mind they have no agenda no plan an fainting memories of  a father  who died making no money on his invention. 
I was simply ask to  donate money,  but if the amount of money  will be sufficient enough  than   I'm going to get all of the secrets  available .


Another words I understood it as:
-we want  to  make technology  available  to  humanity
-we need money  and we have team, we have web page.
-we do not give information  about any progress form the past  and  from the present time as this is  our proprietary achievement.
-However if you pay us enough of money than we are  willing to stop working on it as you have got everything what we know,
but you must remember that if you get yourself into any results  promising profitable activity in this area than
we need  part of it as  we are  the family of  that great man  whose work  you used. 

summary:
There is no work  no real value and no  development.
After few weeks  of exchanging information  I have got myself  into a.... conclusion that
yes... it is a  group of people family members  called Team.- with no  technical skills  and no work in progress.
Whatever is donated is used for life expenses of the people behind it.
But of course this is my impression  and you may  have different one.

Wesley

PS: by the way  real value for free   look  here
  https://www.youtube.com/watch?v=SEQTer29Vq4&t=12s

This is new video:
https://youtu.be/2wVuoNt354o
-motors,
-Magnetic Levitation,
-Human ❤ Levitation
-Superconductivity,
-Aurora Borealis,
-magnetic pressure
-temperature based   experiments
-levitation of a woman