Overunity.com Archives is Temporarily on Read Mode Only!



Free Energy will change the World - Free Energy will stop Climate Change - Free Energy will give us hope
and we will not surrender until free energy will be enabled all over the world, to power planes, cars, ships and trains.
Free energy will help the poor to become independent of needing expensive fuels.
So all in all Free energy will bring far more peace to the world than any other invention has already brought to the world.
Those beautiful words were written by Stefan Hartmann/Owner/Admin at overunity.com
Unfortunately now, Stefan Hartmann is very ill and He needs our help
Stefan wanted that I have all these massive data to get it back online
even being as ill as Stefan is, he transferred all databases and folders
that without his help, this Forum Archives would have never been published here
so, please, as the Webmaster and Creator of these Archives, I am asking that you help him
by making a donation on the Paypal Button above.
You can visit us or register at my main site at:
Overunity Machines Forum



Kapanadze Cousin - DALLY FREE ENERGY

Started by 27Bubba, September 18, 2012, 02:17:22 PM

Previous topic - Next topic

0 Members and 97 Guests are viewing this topic.

Print
Go Down Pages 1 ... 4283 4284 4285 4286 4287 ... 4758
User actions

T-1000

#21420
June 13, 2019, 04:04:30 PM
Quote from: NickZ on June 13, 2019, 01:24:34 PM
   T-1000: 
   Something like what Stalker is showing in this video below.  I can't understand most of it, but I think that I get the idea.  However, this CT is being tested on the 3t coil, not on the Earth ground line right? 
    https://youtu.be/NGG8Hk68Ikw

   
In that video he explained how to tune current transformers for showing proper indication of current phase on 90 degrees in series resonance part from the yoke. This is done by changing resistor values and also then marking exact pins where scope pickup and ground was connected when getting correct readings.
The signal from CT is used in circuit pickup signal later on. Also he uses 2 resistors in series for producing less heating and protecting them going outside of measurement range and not letting them burn.


Also for the ground CT I suggested the frequency range is much higher(100kHz-5MHz, the ferrite cores are limited on that) so it will be bit more tricky to make it read current properly. And if it is exactly a case with max current from ground for proper device operation the output from this CT can become feedback signal for Tesla coil driver later on with proper circuit design.


Cheers!

AlienGrey

#21421
June 13, 2019, 05:15:24 PM
Nick T1000
Any chance you can show us how to setup the TL494 timing diagram ?

r2fpl

#21422
June 15, 2019, 02:17:48 PM
The rise effect is enhanced when grounding is connected to HV. There must be an appropriate frequency and type of pulses, in other cases there is no gain!

https://youtu.be/-eJBNyCn4_M

AlienGrey

#21423
June 15, 2019, 05:05:52 PM
Quote from: r2fpl on June 15, 2019, 02:17:48 PM
The rise effect is enhanced when grounding is connected to HV. There must be an appropriate frequency and type of pulses, in other cases there is no gain!

https://youtu.be/-eJBNyCn4_M
Well Dr Steven greer has given us a few hints about that over time regarding how aliens get here from miliilions of light years away if you could charge a huge capacitor or battery at that spread all your problems would be solved in this forum.
However as he also points out it would creat another one regarding Bull shit.  :o

r2fpl

#21424
June 15, 2019, 05:41:54 PM
Has anyone had a similar effect that can match this oscillogram? It looks like a negative resistance.
Print
Go Up Pages 1 ... 4283 4284 4285 4286 4287 ... 4758
User actions