Overunity.com Archives is Temporarily on Read Mode Only!



Free Energy will change the World - Free Energy will stop Climate Change - Free Energy will give us hope
and we will not surrender until free energy will be enabled all over the world, to power planes, cars, ships and trains.
Free energy will help the poor to become independent of needing expensive fuels.
So all in all Free energy will bring far more peace to the world than any other invention has already brought to the world.
Those beautiful words were written by Stefan Hartmann/Owner/Admin at overunity.com
Unfortunately now, Stefan Hartmann is very ill and He needs our help
Stefan wanted that I have all these massive data to get it back online
even being as ill as Stefan is, he transferred all databases and folders
that without his help, this Forum Archives would have never been published here
so, please, as the Webmaster and Creator of these Archives, I am asking that you help him
by making a donation on the Paypal Button above.
You can visit us or register at my main site at:
Overunity Machines Forum



Kapanadze Cousin - DALLY FREE ENERGY

Started by 27Bubba, September 18, 2012, 02:17:22 PM

Previous topic - Next topic

0 Members and 48 Guests are viewing this topic.

NickZ

   conico:
   I really can't remember concerning a phase shift.  I think so, but I was not specifically tuning for a phase shift, but for best sync, instead, between just the induction circuits. And those coils have all been made to the specs. And, also which of the tuning caps on both induction circuits provide for the best output at the load of several hundred watts. Regardless of where we think that the sync should be, by doing the math. As that calculated resonance point by math, has not worked out for me, in practice.
  One of my shortcomings is, that I don't have a varied selection of those very expensive WIMA caps to tune with. And when using lower voltage caps we can be losing some of the valuable HV gains. Which may only to be found if using those WIMA 2000v capacitors, instead of those cheaper lower voltage caps. As I am dealing with Kacher voltages of at least 5000v. And I have blown even the 2000v caps, on the output series circuit.
So, I think that this is where and what I need to work on. But, it's very expensive having to use only the right wima capacitors for the job, just to see which ones work best. That's why accurate schematics with all the proper voltage and frequency test points is crucial for success.

conico


NickZ

  The 2000v Wima caps 0.47 tell me what a  few of those will costs...

conico

470Nf = 0,47uF at 2000v is 3.2 US dollars it works at 700v AC. If you buy 5 it will be 2.92 dollars / piece

470Nf or 0,47uf at 1600v is 1 dollar and a half, it works at 650v AC

AlienGrey

Quote from: conico on June 05, 2020, 02:50:55 PM
470Nf = 0,47uF at 2000v is 3.2 US dollars it works at 700v AC. If you buy 5 it will be 2.92 dollars / piece

470Nf or 0,47uf at 1600v is 1 dollar and a half, it works at 650v AC
So lets stick to basics, whats the inductoance of the Grenade inductance winding ? lets say its about 159 micro henrys and you are using
a 470 Nano Farad cap in series so whats its resonant frequency ? 3mhz I don't think so as the TL494 has a maximum frequency of abot 500khz.

AG