Kapanadze Cousin - DALLY FREE ENERGY

[AlienGrey]

Guy's this 1/4 wave thing are we talking 1/4 half the frequency (1.8Mhz) or 1/4 the wave length
there is a difference, Wesley was talking about 3/4 along the katcher coil and a tap
that isn't 1/4 wave and then there is 1/4 way along from the earth tap or are we guessing ?
Oh and 1/2 wave tap aint 1/4 wave, is it! ??

Sil

[NickZ]

  AG:  My grenade coil is 37.5 meters long, and the inductor is 1/2 half as long, as the grenade coil 
Others have tried the shorter 1/4 size inductor, also. I've tried both, and the 1/2 as long size worked better, for me.
   Guys: please don't suggest things for me to try, show what you can achieve, instead. I will then pay attention to more than just your opinions, and guesses, by those that have never built this device.

[AlienGrey]

Nick don't alter any thing !!!
and Yes I noticed that on a test rig up, like that it wouldn't start, any shorter and it wont catch to oscillate. Any way who says it has to be 1.8 Mhz.
what I'm asking is SL's are we going up or down in frequency >?  1/4 wave of 1.8mhz is 45 KHz or is he going
the other way 1/4 x 1.8 is 7.2MHz.

Lets be STREATE and to the point here ! because is that frequency a bit too high for an audio / ultra sonic frequency ?

Sil

[NickZ]

   AG:   I have noticed that the higher than 2.5MHz for the Kacher frequency,  the less out put you get from that signal . So that is a limitation on the high voltage end of things. As well as 13KHz is as low as my push pull will go down to. I follow the schematic, not guessing about this
Why 18KHz, because that's where I get the best sync and output at the bulbs.
  Like I've said to you many times, every single self runner is running at different frequencies. Your matched frequency ideas are just your imagination. I explained the reason for that, already.

   NickZ

[AlienGrey]

   AG:   I have noticed that the higher than 2.5MHz for the Kacher frequency,  the less out put you get from that signal . So that is a limitation on the high voltage end of things. As well as 13KHz is as low as my push pull will go down to. I follow the schematic, not guessing about this
Why 18KHz, because that's where I get the best sync and output at the bulbs.
  Like I've said to you many times, every single self runner is running at different frequencies. Your matched frequency ideas are just your imagination. I explained the reason for that, already.

   NickZ

I know what your saying but hunour me here if it sounds mad but what frequency is your katcher running at ? as i think the katcher has some kind of device knocking out pulses in the ones that work as the 494 would be impossible at 1.8 Mhz strugaling at above 400khz, and the Ferrox wont go below TV line scan frequencys. so nouthing adds up !



Sil