TK device, TPU.. Only enter if you seek truth. Cause here it is...

[verpies]

This is the circuit I have do drawing ,and some modifications, this drawing originally is from internet, i just do some improvements only from here, so please take note and reply.

Is B1 connected to B2?
What field are the two 220t receiving coils immersed in?

DCV: 68.4V
In the capacitor i measure ,its stop raising until this value.

The voltage across the 22mF capacitor is dependent on dI/dt of the current flowing in L2 and inductance of L2.
If you add more turns to L2 or cause the Q1 & Q1 to turn-off faster, then the 22mF capacitor will be charged to a higher voltage through D1.

[verpies]

I need help, If anyone wants to help me in building a circuit controller for my Tariel Kapanadze device.  Please PM me.  I am in nned of some one who can build a small Electronic Electrical Circuit Controller and also a PLL, which is a Phased Locked Loop circuit controller.  I am on to it and need help.  It is above my abilities to make these 2 circuits.  I can make everything else. 
PLL is needed (for Magic 'y) in order to achieve synchronization between the "transmitter" (inductor) and the "receiver"

Do you need a digital or an analog PLL? What is the frequency and shape of the waveforms, that you want the PLL to output and synchronize to, at its input (phase detector)?

[segar]

HI, verpies

As you said di/dt  ,i want to increase the current according to my circuits as i have post to you, so how to increase the current for output ,now i only get 50mA max voltage 70vdc , now i want to increase the current,,,?

please give some input on it, in the circuits

thanks verpies

The voltage across the 22mF capacitor is dependent on dI/dt of the current flowing in L2 and inductance of L2.
If you add more turns to L2 or cause the Q1 & Q1 to turn-off faster, then the 22mF capacitor will be charged to a higher voltage through D1.

[verpies]

You did not answer my previous questions (all of them have question marks at the end).

now i only get 50mA max voltage 70vdc

Where is that voltage and current measured?

[elementSix]

Do you need a digital or an analog PLL? What is the frequency and shape of the waveforms, that you want the PLL to output and synchronize to, at its input (phase detector)?

I not totally sure, but I think it needs to range between 6.50Hz to about 40 Hz.. But I am still not sure.   Can they be adjustable and still be self adjusting??  Square wave and yes Phase detector.  This is one idea from this russian site, but I don't understand it..
next post will paste pic

Do they Sell these somewhere, that are for TV and adjustable??