Free Solid State/mechanical energy

[wizkycho]

Hi Igor,

Not so fast, please...    I did not mean to be negative on you or to show you that I achieved any remarkable results with these capacitor charging/discharging circuits because I did not.  Sorry for this, I cannot report any overunity success yet.

On a conterary I think You where not in any way negative but constructive.
But if EMF recycler showned undoubtably chalorimetric Free Energy (and to say lots of it) it is most
likely a matter of simple electronics to make it OU.
So I just wondered how many have built this or something simmilar but keeping it quiet about.
Of course this gives them advantage in this space and time.

I'm thinking of the same strategy.

This sentance is the best way to keep it from public 
"telling to gass station plant guy that at your home you do everything on electricity and in the same time telling electric company guy that even your TV set is propeled with gass, and if somebody tries too sell you wood you just "admit" that Your house uses gass and electricity"

You can't just tell them "dissconect me" cause
emidiately they will start sniff around. And I'd rather would like to see WIB (Women In Black) than MIB. I just wouldn't know
what to do with MIB - I might hurt him.

wiz

[FreeEnergy]

http://www.overunity.com/index.php/topic,903.0.html

[PaulLowrance]

wizkycho,

Could you please reply to my post.

Paul Lowrance

[wizkycho]

to gyula
--------
In test1.1

on 220V secondary I conected greatz and  100uF to +- of greatz.
After discahrging full (at 6.2V) one capacitor 470u through
primary 2*24V to empty 470u both were at 3.15V and 100uF on secondary got 3.3V.
If repeated 100uF got arround 2.5V in every cycle

in test 1.2 (emidiate power back)
I disconected 100u (C5) and conected output of gretz +- to fully charged (6.2v) 470u at primary winding
After discharge through primary to emty 470u both caps ended up  at 3.4V.
It is a small change 3.15V to 3.4V.

in test1.2
I think 470u + 470U is to low impendance for secondarys such a short pulse.
what is needed is to use say 10u and discharge it after few pulses...

I'm going to build it parametrically (EMF Recycler)...

to Paul Lowrence
-----------------
I'm avare of equations and I'm not stating free energy

[gyulasun]

Hi Igor,

thanks for the info. Yes, the small voltage value you receive in the 100uF capacitor is because  it is placed in the secondary and there the back EMF of the 2 x 24V primary cannot induce any useful voltage.  I agree on trying lower value capacitors to find the best charging up time (4.7-22uF).

If you have a look at Naudin's site on his scalar battery charger circuit, you can find MOSFET switch circuits with their drivers what you can use for the EMF recycler too. The link is:
http://jnaudin.free.fr/html/scalchrg.htm

Regards
Gyula