New Perm Mag Engine Design 1.5 : 1 Ratio (work from magnets)

[Floor]

I won't be able to post the complete set of drawings, or  photos of the test devices in a single upload. There are too many of them (27).
I will be looking for design suggestion / input, on a high efficiency linear elect. gen. for the cyclically operating  prototype. I have acquired many of the materials for a (hopefully working)  prototype, neo mags, precision axles, ball bearings, and other materials.  I am still playing with / drawing the architecture of the new model.  The original test device is crude, and has a lot of friction losses.  It was necessary to vibrate
the model (drum upon it with finger tips) in order to get full actuation of the components. 

[Floor]

Note. In the drawing (Figure  9  Position 1) magnets RO are  incorrectly labeled. The face of magnets RO should be simply labeled as "N" or north.

[lumen]

It's good to see someone testing the theory of operation before building something in hopes of it working.
Testing the theory usually requires enough building in itself.

I am about to test a similar idea, except I found a way of rotating the magnet that requires no work and it will use both attract and repel in it's operation.

[Floor]

Thanks for the response

Very cool ! I hope it's a goer. Do you have any photos?

[Floor]

One more photo