The new generator no effect counter B. EMF part 2 ( Selfrunning )

[gotoluc]

Looks like you're spinning your wheels MileHigh... no one cares!

They are searching for perpetual motion and will perpetually continue till they get there without obeying the Laws of Science.

Regards

Luc

[Jimboot]

Really learning a lot from everyone's builds, videos and designs. Thanks

[MileHigh]

Looks like you're spinning your wheels MileHigh... no one cares!

They are searching for perpetual motion and will perpetually continue till they get there without obeying the Laws of Science.

Regards

Luc

On the contrary Luc, anybody that has been following this thread cares about understanding what your setup is doing, and what the YouTube guy's setup is doing.  The forum participants and readers care about the overall generic issue.

You seem to be suggesting that your setup may not obey the laws of science?  That would be unwise and actually ridiculous.  Your setup is 100% conventional.  You are just copping out, something we have seen before.  Perhaps between the group here and the group on EF collectively you will be able to make some sense about what your tests are really doing.

Correct the problem with the power dissipation in the generator coil and then try to account for where the power is going.  That's a bare minimum that collectively you should be able to do together - no putting your heads in the sand.

MileHigh

[thngr]

The magnets have to be stationary and the rotor is switching magnetic field. In your design the magnets are moving which are no different than in conventional generator.

Cheers!

to t1000
you are not seeing it 

[thngr]

to luc
I'm looking forward to your experiments and appreciate your efforts also. (I think you need two sperate coils. diode also needed to sperate the effect if it is the time while inducing magnetic field to coil or while it is collapsing)