Lenz free generator

[tinman]

Congratulations! That looks (and sounds) quite promising!  Two or four poles on the rotor? Much clearance?


Will be watching, thanks for sharing


Ron

There are 4 poles on the rotor-alternating pattern-as the scope shot reflects.
The clearance ATM between pole pieces and rotor magnets,is about 10mm-but still yet to fine tune that,as this was just a quick !throw the rotor on,and give it a spin! run.

Quick P/in-P/out measurements.

P/in= 24v @ 350mA
P/out-as per scope values=
coil A= 6.6 VRMS over 10 ohm resistor
Coil B= 7 VRMS over 10 ohm resistor.
There is also a 12 volt battery being charged at the same time,but i did not calculate for that.
Even so,there is obviously a large measurement error there some where,and i will find out where it is over the weekend.


Brad

[i_ron]

It's been a few days, and as is usual, no one seems to give a damn about the real issue.  Why in the hell is an increase in inductive reactance being celebrated as a step in the right direction? 


This is complete and utter insanity, in a word, USELESS!  I mean no offense, however, it seems that the intelligence of those who do think is being challenged, and as such something must be said.  We are well aware of what governs consumption in motors....right?  Understanding that, when the consumption drops, we must refer back to that which governs consumption!  From here its clear that the application of load modifies the reactive cross section of the motor circuit, in this case is not so much an increase in inductance, but more like the voltage and its associated current which are induced in the generator winding proper, are of such a polarity and phase that it augments the motor CEMF, raising it, the mechanism for this augmentation is transformer action, transformer action in a circuit of poor geometric relation. 

In the end, the motors ability to limit its consumption has been amplified by a whopping 50%!  Lenz isn't helping you here, hes getting 50% more out of you, but who am I....you people can and will believe whatever you want. 


Regards

I was bring quiet because I was looking at JB's zero force motor... and didn't want anyone to find that out, lol


Ron


PS: do you have any models or drawings to illustrate your ideas?

[i_ron]

About a month ago I uploaded a video demonstrating an unconventional means for generating acceleration under load.

regards

Is the video still up? do you have a link please?


Ron

[Grumage]

Is the video still up? do you have a link please?


Ron

Dear Ron.

Here you go.....

https://www.youtube.com/watch?v=OOBNFgayaAc

Cheers Grum.

[i_ron]

Dear Ron.

Here you go.....

https://www.youtube.com/watch?v=OOBNFgayaAc

Cheers Grum.

Thanks Grum!


Ron