-----> Massive Amperage From OUTSIDE The Transformer Core Lamination's.

[FatBird]

Does anybody have any thoughts on this.  In his video he is getting MASSIVE Amps from 1 Turn OUTSIDE the Transformer Lamination's.
Transformer Textbooks dogmatically state that all winding's must be around the inside Laminated core itself.  NOT THE OUTSIDE!!

https://www.youtube.com/watch?v=EDH7s3IMTtE

I'm wondering what would happen if he used SEVERAL turns?

Any thoughts?
                                                                                                          .

[Magnethos]

If you read the comments, he has wrote that inside the transformer he can get 800 amperes. That is not shown in the video, but explained in the comments.

[Magnethos]

I've also read (in different source) that it's not affected by Ohm's law. That wire has a non-usual behaviour.

[Dave45]

If you read the comments, he has wrote that inside the transformer he can get 800 amperes. That is not shown in the video, but explained in the comments.

I was wondering if the shorted coil on the outside effected the inside.

[seychelles]

HI ALL .THE VOLTAGE MUST BE VERY LOW BECAUSE THE LOOP SHOULD HAVE BEEN BURNING UP WITH ALL THAT CURRENT.. THIS VERY VERY INTERESTING. IT JUST SHOWS YOU THAT WE HAVE NOT BEEN TAUGHT EVERYTHING IN THE ENGINNEERING SCHOOL. THANKS FOR BRINGING THIS INTO LIGHT.. I GUESS WE JUST HAVE TO USE OUR IMAGINATION WITH THIS PRINCIPLE FROM THERE ON..