Magnet force shield

[Floor]

@Dieter

It looks like Gotoluc is takeing some well derserved time off,
             (at least from the builds in public ?).
..................................
..................................
My last presented shielding method, has proven once again to be ineffective.

Friction between the bottom of the repelled magnet stack and an epoxy residue
on the bench, facilitated an miss perseption of the of the shielding
alignment's effectiveness.  That effect is more appearant when viewing
the video than when one is actually manipulateing the magnets oneself.
..................................
..................................
User "Woopy's" observations of that "magnet shield" (on the TD replications) topic
were pretty much accurate.  (Thanks Woopy)

          here   @    http://overunity.com/16987/td-replications/msg502305/#msg502305

Also credit is due user Norman6538 for his observations (on this topic) which may have been
the same / similar to Woopy's, although he did not eloquate them .

When I installed the repelled magnet stack onto my linear bearings / slideing unit
... boom ! .... no buneo ! .... so onward.
..................................
..................................
Your last FEMM files may have been more useful than I initially thought they would be.

They led me back toward,  a previously mentioned by me

                   "There is yet another 3 magnet interaction set I want to diagram."

That is the method I'll be putting up next ......but with full details / measurements compleated.

                        I like this one  a lot....although it's a little bit of a complex arrangrement....

                 Thanks
                      best wishes
                                 floor

[Floor]

@  all readers
I have deleated my recent video "magnetshield-1" WHICH DID NOT WORK and

which was @  http://www.dailymotion.com/video/x5eg7kk_magnetshield-1_tech

best wishes
    floor

[Low-Q]

@  all readers
I have deleated my recent video "magnetshield-1" WHICH DID NOT WORK and

which was @  http://www.dailymotion.com/video/x5eg7kk_magnetshield-1_tech

best wishes
    floor

You might have an explanation why the magnetic shield didn't work.
I think it's important to take failures and turn them into education so others doesn't spend time doing the same mistake. You know how people are in this forum. Unmistakeable people, convinced they have found a solution to an impossible problem.

[Floor]

@l readers

Here is the "yet another 3 magnet interaction" in video.

@                    http://www.dailymotion.com/video/x5gqomq_yetanothermagset_tech

                No measurments yet either.

                 floor

[Floor]

@ Low-Q

Nothing risked ..... no failures
Nothing risked..... nothing gained.
I have the freedom to fail and to succede.

          floor