Tom van Keulen coil v9 setup free open source

[indigo22]

part 2 https://www.youtube.com/watch?v=yHg2jWrae60&feature=youtu.be

[indigo22]

part 3 sorry 4 tha quality didn't do anything different weird shit man anyway part 3 https://www.youtube.com/watch?v=wYerGuGISnk&feature=youtu.be

[PARAV]

part 3 sorry 4 tha quality didn't do anything different weird shit man anyway part 3 https://www.youtube.com/watch?v=wYerGuGISnk&feature=youtu.be

Hi Tom,
Thanks for sharing all this info .
In my 10 years on this forum --your set up looks like one of the most promising free energy ideas I have ever seen.
I too have a couple of questions.
Can you show us how to make the break out board? ?
Where is the breakout board connected in your version 2  ?
Can I use a couple of 12 volt batteries for the PS (24volts)?
Did you say that the frequency was around 20 kHz from the PWM ?
Sorry for all the  questions..
I've started winding the coil and will be standing by for further.


Thanks again and keep up the good work
Paul

[indigo22]

hi Paul glad 2 help

Can you show us how to make the break out board? ?

yes please check picture

Where is the breakout board connected in your version 2  ?

after it went into the coil then into the pwm breakoutboard into the ground

Can I use a couple of 12 volt batteries for the PS (24volts)?

i rather play with the magnettic bias frequentie and size instead of pomping more volts and amps into it

Did you say that the frequency was around 20 kHz from the PWM ?

Depents on the load some lightbolps have different frequenties on the sweatspot in this case with 1 lightbulb 27 microseconds on 57 off

btw you can also use the energy to load up batteries

[indigo22]

whell this studie didn't come cheap i blew up dozens of arduino's raspberries transistors controlboards etc
right now i'm outha breakoutboards sow will send the next video soon

if you have any questions please ask don't be shy