Overunity.com Archives is Temporarily on Read Mode Only!



Free Energy will change the World - Free Energy will stop Climate Change - Free Energy will give us hope
and we will not surrender until free energy will be enabled all over the world, to power planes, cars, ships and trains.
Free energy will help the poor to become independent of needing expensive fuels.
So all in all Free energy will bring far more peace to the world than any other invention has already brought to the world.
Those beautiful words were written by Stefan Hartmann/Owner/Admin at overunity.com
Unfortunately now, Stefan Hartmann is very ill and He needs our help
Stefan wanted that I have all these massive data to get it back online
even being as ill as Stefan is, he transferred all databases and folders
that without his help, this Forum Archives would have never been published here
so, please, as the Webmaster and Creator of these Archives, I am asking that you help him
by making a donation on the Paypal Button above.
You can visit us or register at my main site at:
Overunity Machines Forum



Would this be a good solid state solution to measure the inrush current?

Started by Belinga, January 15, 2018, 04:38:38 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages1
User actions

Belinga

January 15, 2018, 04:38:38 AM
Background:

I've a problem where I need to measure the inrush current of some parallel DC/DC converters in a system where the input voltage may vary between 360-600Vdc on start up. The inrush current is roughly estimated to peak around 500A for a short duration before settling for a max current on around 15A.

I've previously tried with a mechanical relay however that particular relay, bounces on and off before making a solid contact making me unable to make an reliable measurement. Therefore I need a solid state switch solution.

The measurement is done by a current probe , P6303.

Idea

Despite my non previous experience of thyristors my idea is to solve this with the use of a thyristor. I think that I in this way will get a faster and less noisy switch than the mechanical relay.

At the moment I've a MCD56-12io8B thyristor(http://www.kynix.com/Detail/1309829/MCD56-12IO8B.html) laying around,which I think I can use as followed:

(See attachment Rqzsf.png)

I have also thought of skipping the SW in the circuit and just turn on the Voltage of Vc, directly from the bench supply and hope it doesn't exceed the Vgc max.

I know that in this configuration I will only be able to turn on the thyristor however this is not a problem. I will just turn off the supply (vin) for that.

I guess the low-side solution would be easiest and safest. However I'm a bit unsure what will be the maximum allowable gate voltage for the thyristor. I can't find Vgc max or any equivalent in the datasheet to what "vgs max" is called for mosfets, which I'm familiar with, but I guess if i'm below 4V it will be chill. If you look at the pic below from the datasheet fig 5

(See attachment L5W4z.png)

Right now I would set the gate voltage to slightly above the gate trigger voltage, and the current through the gate to a value above 100mA

(See attachment cuJ7y.png)
May this be a good solution to my problem or should I just buy an expensive ready made solid state solution..
Print
Go Up Pages1
User actions