170 watts in - 1600 watts out - looped - Very impressive build and video

[Jeg]

Pmgr
Thanks a lot for this great simulations. Is it out of a commercial software?

[konehead]

Hi Luc
For Pierre, my two cents worth of advice:
I would say the circular inner core will pull out lots more power, however there may be unforeseen complications, and it could cause overloading to primary inducing into it, and there is  "backup" and suddenly the system draws 10 times more power in the input but I don't know...just leave everything the same, then try the new rotor....
Someone said that the core should be "AC friendly" so this means laminate steel, and the stell plates insulated too from one another too with varnish or whatever...
So be careful! Do not ruin or destroy what you have!!  - proceed one step at a time so you can always step back and correct.  You know all this I am sure
Keep going and don't stop eh!

[pmgr]

Pmgr
Thanks a lot for this great simulations. Is it out of a commercial software?

I use FEMM. It's open source.


PmgR

[iflewmyown]

PmgR, Very nice work also. Thanks
Garry

[tinman]

1: https://youtu.be/7vN0wpY2lok

2: https://youtu.be/7EHOyN6FwWE

3: https://youtu.be/kJdOJybH1LY

4: https://youtu.be/RKkCQlPJ8wM

5: https://youtu.be/WFRmhGIaWoI

6: https://youtu.be/QqzFRzILUC8

Even if nothing becomes of it Luc,that winding job is something to be proud of.

Well done


Brad