O.U. Magnet force shielding 1

[Floor]

It is true that rigid and precise construction are required.

After I do this next presentation, maybe I will put together a materials list
and complete drawings and instructions topic ?





regards
   floor

[ramset]

There are many more open source builders for this project
I believe people are a bit spent or shellshocked from the world
Around us ATM


That being said
One good anomaly will ring a bell to wake/bring the open source builders to the call !
( and I will knock on many doors to spread the word !)


With Tremendous gratitude


Chet K

[Floor]

Little update.

Thank you Ramset.

A photo of my test bench. 

I'm epoxy gluing the fixed and output magnets, each to its own fixture / mount.
Less clutter / no clamps and also this gives increased precision.

Cleaning up and organizing the test bench / area.

   best wishes
         floor

[norman6538]

I finally got a wheel together enough to see that there is no significant sticky spot and this is the real deal....But its too ugly for a photo....

So guys go for it.....But due to the rigid construction and precision and the opposite angles it will take a while to finish....

I just wish it could be scaled down but smaller magnets have less power and tolerance has to be much closer. I wish Butch Lafonte could see this...

Norman

[Floor]

@ all readers

https://overunity.com/18928/magnetic-force-neutralization-method/msg560038/#msg560038

   floor