Tommey Reed's Pulse Magnet/Generator project

[TommeyLReed]

Hi All,
This is my design of a magnet/generator design.
How it works:
There is a center shaft that is stationary that has a North and South magnet attached to the shaft. The field winding rotates on the outside like the Joe Newman motor.

This also has two magnets outside of the rotating field winding to increase magnet flux field on N/S. At 90deg there are two more magnets stationary to generate power output.
There are no iron core to increase flux to generate power, this would cause cogging effects. This will allow low power input to by theory increase output at 90deg.
The BEMF is collected as the field turn off after energized to cause rotation. A encoder and microcontroller would be need to control the timing and charging circuit.
Tom

[TommeyLReed]

Next picture

[TommeyLReed]

Hi All,
I never like a theory, it's like telling someone a story without facts.
This is my intro video to make a theory into fact, even if it doesn't work I would have real data instead of a theory.
https://www.youtube.com/watch?v=bTxbUF_4r5M
Tom

[TommeyLReed]

Hi All,
I'm explaining how this pulse magnet motor/generator works.
As you all may know, I don't like theories, that's why I'm building it to verify with some real data.
I would like to have some input form anyone, being open source is something I truly believe.
https://www.youtube.com/watch?v=Jn9GmCklhMc
Tom

[TommeyLReed]

Hi All,
Just finished the coil and load tested using ohms law.
https://www.youtube.com/watch?v=1hTltjOJhX0
Tom