Igors switcher (EMF recycler2)

[wizkycho]

drSpark. When using simmulator circuitmaker2000 i'm getting same very much OU results.

The main difference when switching with relays (especially 4pole ones) is that there can not
be two outputs closed with one input contact. so there is allways strictly one paralel and one serial cond bank.

On the other hand in schematic with 6 MOSFETS there is a time when all 6 of them are opened/closed (no matter how fast rise and fall are) because when 10Hz source is at V/2
both Transistors are still conducting (probably satturated) so the conds are not neither in serial or paralel mode (on both sides)

In a schematic two with 3 mosfets one capacitor bank is allways paralel and the other changes paralel,serial (but again not strictly).

I run simmulation (sligtly modified schematic with 6 FETS) but with small pause between each transistor closes then other opens and gave me NO OU result.

When simulating Your schematics (no strictly defined opened or closed cap bank in a time period)
I wonder what are all the possible ways where the charge is flowing.
One of the most important,I think, is that when current flowing from source to both banks at the same time creating bucking flux flow in a core of Trafo which returns high back EMF which must be collected by the either of 1+2 capacitor banks and shown as rise of voltage.
I give this circuit very high probability it will work.

The question is: Are the simmulation programs that advanced that they are actally calculating
bucking fluxes in a trafo itself and calculating possible back EMFs ?

If so that would be an explanation why this device really works

Igor

[drspark]

A snipet from the CM manual.

[gezgin]

in simulator , some coil tests circuit&waves :

[drspark]

next ill try to buck the ct winding

[drspark]

Bucking ?