Centrifugal Energy Multiplication Machine

[panyuming]

Thanks  Hazem for sharing!

Hopefully some similar charts can be simulated. Thank you!

[Hazem]

Thanks  Hazem for sharing!

Hopefully some similar charts can be simulated. Thank you!

You are welcome panyuming. Yes, I am planning to make a dynamic simulation using Autodesk inventor and posting the result along with charts similar to yours. But this will take some time since I have to learn how to deal with such technology.

[Hazem]

Hello everyone,

I have done digital simulation for the "Elliptical Orbit Drive" to clarify its characteristics even more. I am sorry for the low quality, my computer is somewhat old. I hope you enjoy it.

Regards

[Tarsier_79]

Hi Hazem

I built two devices using a similar CF principle. I used bike gears and chain instead of meshing gears (on the larger device I built) In the end I had a problem latching it at 60rpm, which was the ideal speed to lift a suitable secondary weight into over-balance.

https://www.besslerwheel.com/forum/viewtopic.php?p=187751#p187751
(Sorry, have to create account at BW.com to see)

[Hazem]

Hi Hazem

I built two devices using a similar CF principle. I used bike gears and chain instead of meshing gears (on the larger device I built) In the end I had a problem latching it at 60rpm, which was the ideal speed to lift a suitable secondary weight into over-balance.

https://www.besslerwheel.com/forum/viewtopic.php?p=187751#p187751
(Sorry, have to create account at BW.com to see)

Hello Tarsier_79, I hope you are doing well.

I believe it is very tricky to keep chains and bike gears in synchronization within the existence of vibrations, not to mention the unstable wooden structure. Please concentrate on hardening the machine's main structure and its stabilization, then you can tackle the next step. Doing that will save you time and protect you from depression .