Plasma Electrolysis by IronHead

[Moab]

I will get into the flip circuit and pulser after we get some good solid burns. There is lots to build as a heater. most stuff is as simple as a crank. First thing is to get a bridge, some tungston,a screen, some kind of heat resistant vessel to put it in and spark that cell up.  .M.

[Robb077]

The Russian version....how plastic parts hold up I don't understand.

http://guns.connect.fi/innoplaza/energy/story/Kanarev/book/1202.html

[IronHead]

because the water  in the container / reactor only goes to 180F the highest it can go is 212F without being under pressure.  and if the plastic is rated at 300F  then it holes up to the temp.

[Robb077]

Ironhead:
The big dream is to have about 5 of the 1 amp plasma devices under pressure to power a home power station like this....need about 100k btu.


http://www.nemw.org/ECR022103revised.pdf

[IronHead]

Oh right  I gotcha . Might want to start small first to test what happens under pressure and if the whole concept you have even works.

Just my 2 cent