Plasma Electrolysis by IronHead

[keithturtle]

If the nozzle is aluminum and the screen is attached to it, then, man, that's gotta put a heck of a load on yer shrink wrap!   Also, yer jes a wrap's thickness away from a dead short, if'n I got yer cell pictured right...

Turtle

[keithturtle]

Here's a pic.   Sandblast tip is supported in an acrylic cradle, clamped to a thick polycarbonate bridge across bucket.

Screen bolted to UHMW sitting on bottom of bucket, whilst SS thr rod exrends up to get clamped to bridge.   Grabbing while running was quite a shock.   Thenceforth, wrapped with tape.

Pos to rod, neg to screen on this one.  That'll be fixed next time 'round

Turtle

[IronHead]

lookin good Turtle

[Robb077]

Looks nice. Where's the plasma?

[Robb077]

Turtle:
Just joking Turtle, as "where's the beef?" You got more done than I have on this project....not so easy as it looks. Hope the reversing polarity helps.