new magnetic motor goes 2000 rpm without load 1000 rpm with load

[magnacoaster]

i watched that video the only problem is he will make the magnets brittle due to the power going into the magnets this was not a great idea.

no i do not have to use spark gap it will run on the new timing device just fine
we use the vortex's off the magnets to drive the voltage and amperage  higher

i will shoot a video this week as i hook the unit all up ad run it for a few days here in the lab maybe
i can even get a  live video feed going so you can watch the unit in action.

right now i am so swamped with all the suppliers i have to deal with to get our
production run ready to go and the new shop setup and running.

yes some times there is more to life then living in my test lab


Richard

[hartiberlin]

Hi Richard.
Many thanks for your infos and help.
It is great to see, that you have succeeded to put out a true overunity device. Surely, it is more important for you now to organise the production, but when you still have some time this or next week, just try to put up a youtube video from the new device.
Live streaming is a pretty hassle, so a good video shot from a tripod camera might be the easiest and best thing for you. Otherwise, if you like to show live video, go to:
www.ustream.tv
or
live.yahoo.com
and stream from there.
It is free to use and you will have a big audience.
So all in all I wish you good luck and can`t wait to see the new device in operation.
Many thanks again.
Regards, Stefan.

[hartiberlin]

Okay, I have downloaded the old video from
youtube and converted it to DIVX.com AVI  codec
with MP3 audio
and it is now here:

http://overunity.com/magnacoaster/magnacoaster.avi

( about 16 Mbytes)

The camera work is a bit shaky
but it is amazing how much power you can draw
out of the device although it is only
powered by an almost dead car battery
and there is only a coil and a few
neodym magnets.

I am going to link the video to the first page onto
this thread and put the thread up as the top news
thread now as one can see, that this is a great overunity
output factor !

Many thanks Richard for making this available and looking forward
to your new device with solid state switching.

Regards, Stefan.

[plengo]

@hartiberlin

so it seams that this device is really a few logical parts:

1) the very strong magnetic field already in place by the neo magnets being switched by the coil. This is the "bridge".
2) the BEMF is collected from the coil
3) the spinning of the wheel is activated by the "bridge" that is created by coil and very strong neo magnets.
4) the timing, as the wheel spins, causes the neo magnets to contact with another point where the BEMF can be multiplied (as demonstraded on the thread http://www.overunity.com/index.php/topic,4124.0.html that you mentioned).

Is this what you realized? is there more?

Fausto.

[magnacoaster]

no what i did was to get 99 % of the power out with a new design circuit and some wild new parts that you cant get off a shielf
also got a coil in there and not a nickle  and got cooling as well