New vids on Stan Meyer!

[hkyle]

will be soon...right know I'm in the middle of wrapping the toroid. Parts are on order for the Lawtons/meyers vic should be here next week.

[h20power]

Yes, Araron has gotten it to work, look on this site: http://blog.waterforfuel.com/2007/04/07/and-the-winner-of-the-free-water-powered-vehicle-is.aspx#Comment

As soon as I map out the electronics, I should get mines up and running, too .

[d3adp00l]

I am gonna use a car ignition coils, easier to find. the signal/power generator is finished. Getting some plates tonight. the only problem I have found is that when I fire up the coil everything is energized to the coils voltage/freq. And I mean everything the entire system, every wire, the control box, all the way back to the 120v/12v ac xfrmr. I have tried diodes but the voltage is too high and goes right through them. Anyone have an idea of how to block this voltage and bounce it back to the coil? Serious amounts of harmonics/resonance. I can't take any measurements of voltage anywhere in the system, as soon as I fire it up every meter in a 10' radius, freaks out and is completely useless. It doesn't matter if the meter is connected to wires or not, they freak out the same. The only meter that works is my ampmeter on the 120v input to the xfrmr which tells me I am drawing .015 to .04 amps @120v = 1.8 to 4.8 watts. Very little draw on the system, and a lot of electrical activity everywhere.

[hkyle]

Go and find a set of microwave oven diodes. Might help. Those are the biggest diodes I could find...free if you go to a repair shop that has dead microwaves.

[d3adp00l]

With the price of microwaves, I think it would be harder to find a repair shop, than to win the lotto.