Overunity.com Archives is Temporarily on Read Mode Only!



Free Energy will change the World - Free Energy will stop Climate Change - Free Energy will give us hope
and we will not surrender until free energy will be enabled all over the world, to power planes, cars, ships and trains.
Free energy will help the poor to become independent of needing expensive fuels.
So all in all Free energy will bring far more peace to the world than any other invention has already brought to the world.
Those beautiful words were written by Stefan Hartmann/Owner/Admin at overunity.com
Unfortunately now, Stefan Hartmann is very ill and He needs our help
Stefan wanted that I have all these massive data to get it back online
even being as ill as Stefan is, he transferred all databases and folders
that without his help, this Forum Archives would have never been published here
so, please, as the Webmaster and Creator of these Archives, I am asking that you help him
by making a donation on the Paypal Button above.
You can visit us or register at my main site at:
Overunity Machines Forum



This is my Hydrogen Cell: 1st Attempt.

Started by Mad_Scientist, June 07, 2007, 06:52:04 AM

Previous topic - Next topic

0 Members and 2 Guests are viewing this topic.

Print
Go Down Pages1 2
User actions

Mad_Scientist

June 07, 2007, 06:52:04 AM
Hi everyone,

My name is James and this is my first post. I want to share with you some pics of the Hydrogen Cell that I have been working on.

It took me about 3 hours in all and works very well.



and another:



and another:



and 1 last pic:



As you can see from the 3rd pic, it is a 2-plate design and doesn't use any neutral plates although would probably benifit from 2 or 3. At the moment it runs too hot so I will investigate pulsed high voltage low amp circuits to get it to run nice and cool.

All feedback welcome.

hartiberlin

#1
June 07, 2007, 10:17:06 PM
Nice design James,
what kind of plastic pipe casing did you use and how did you fix the Stainlesssteel
pipes there ?

Thanks for sharing.

Regards, Stefan.
Stefan Hartmann, Moderator of the overunity.com forum

Mad_Scientist

#2
June 08, 2007, 06:38:21 PM
Hi Stefan,

Thanks for the reply. The plastic casing is 40mm drain pipe coupler with an O-ringed blanking plate at each end. I connected the stainless plates with some stainless M4 bolts bent at right angles and tightened on to the plates with some nuts and washers. The bolts also double as the electrical connections for the electrodes, so that the wires just get tightened on with a nut and washer. The contacts are sealed with a mini O-ring and some washers on each side - it works a treat.

It works pretty well, the only challenge is the heat that is put out. So the next plan is to go a lot higher with the voltage and drop the amps as low as possible to try and keep the temp cool. Time will tell though. Lots of trial and error me thinks.

Oh, and the brass fitting at the end of the gas line is a jet out of a Dell'Orto Mini Moto carb: size 98. It has the effect of increasing the gas pressure inside the unit makiing it easier to direct the gasflow.
;D

IronHead

#3
June 08, 2007, 06:45:36 PM
Good work  Mad_Scientist
Keep on building. If you have any question stop over to.

http://www.overunity.com/index.php/topic,358.0.html

There are a few of us working on HHO over there.

Mad_Scientist

#4
June 08, 2007, 06:51:06 PM
Thanks IronHead,

I will take a look at that thread, I am sure that there is a lot there that I can learn.

;)
Print
Go Up Pages1 2
User actions