Successful TPU-ECD replication !

[eldarion]

...remove the mobius loop! If the device still puts out the same power, then this speaks for itself...

I second the motion!  All in favor say aye...AYE!

Seriously, can someone please perform this simple test?  I am trying to get a replication started, but all my parts have to be mail ordered, so it is slow going.

[dutchy1966]

First things first, slow down guys, and remove the mobius loop! If the device still puts out the same power, then this speaks for itself. That is the most obvious thing to change if you want to prove the device does what you believe it does. It has been brought to your attention, take the 30 seconds required, and try it.

Darren

Darren,

I agree that is a valid test, although Otto has already replied to this by saying it doesn't work at all without the mobius loop....

Robert

[c0mster]

Ok lets test this tonight. I want to first add the second frequency and log what is going on. Then lets take some of it apart. Strefan has set up a location that he feels may stream better so we can try the webcam there.

Cam

[dutchy1966]

Ok lets test this tonight. I want to first add the second frequency and log what is going on. Then lets take some of it apart. Strefan has set up a location that he feels may stream better so we can try the webcam there.

Cam

Great Cam,

Where can we see? 

Robert

[CTG Labs]

@Rich, I have a kill-a-watt meter and also digital lux meter and 4 channel logging thermometer, so I can perform each of these, etc.

@Cam, great!  I would love to know this as we can then tell if the supposed special properties of the mobius strip, ala Prof S Seike are indeed at play here.  Also rather than just disconnect it, also try to connect the top wires of the outer loop to the top wire of the smaller inner loop, etc, ie mobius in back to front mode to check if the mobius twist is having an effect.



Regards,

Dave.