The Lee-Tseung Lead Out Theory

[Pirate88179]

       
They do not believe in the debunkers and insulters (as they paid them to lie and pump out misinformation â€" the pay is tax free but without health insurance).   

Lawrence Tseung
Director
Help Seedlings Innovate Foundation Limited

@ Lawrence:

I am really glad that you have a sense of humor.  Now that was really funny.  Very well done sir.

Bill

[spoondini]

Are you saying you have won the Overunity Prize?  Why is there no announcement about this on the Overunity Prize forum?

He's been stating this horse crap for the last month, still hasn't sent Stephan a unit-because there is no unit. 

[Cap-Z-ro]

There's been a huge mis-communication due to a language problem...Lawrence sent Stefan a unich in error.

Regards...

[ltseung888]

Meeting with the technical evaluator from China

The meeting took over three hours.  He and his team had one of the early prototypes for a few weeks.  Apparently, they did not do much with the prototype.  They only turned it on and saw it rotating.  They did not even take the Input and Output voltage and current measurements.

With this particular prototype, all we need to do was to remove 5 screws.  The entire circuit would be revealed.  The first thing I did together with the evaluator was to trace and draw the circuit diagram.  I had to make sure that he understood the following:

1.   How the Proximity Switch got its power from the 12V battery and how it interacted with the SSR relay.
2.   How the coils can be connected as Drive Coils and as Collector Coils.  The initial configuration was all drive coils.
3.   How Input Voltage and current should be measured.  The measurement should be across the Drive Coils which were connected in parallel.
4.   How Output Voltage and current should be measured.   In the particular prototype, the voltage was not rectified to DC yet.  The evaluator wanted it rectified before doing the comparison.  We did not have the diode bridge available.  That will be done at a later time.
5.   The evaluator took two of his coils with diameter 0.29mm and resistance of 20 ohms.  He put them in series as Collector Coils and got an AC voltage reading of 25.2 Volts maximum.  The reading was taken with our 4 coils acting as Drive Coils.
6.   I than explained the importance of tuning if we want to get Overunity results.  He initially wanted to have a small prototype for Beijing.  After my detailed explanation, he was willing to accept the 60 cm wheel.  He wanted to see the results of the recharging of batteries and the loopback first before approving and recommending our prototype.

We still have some work to do.  The battery experiments will be tomorrow.  If that were successful, the loopback tests should take place a week later. 

Lawrence Tseung
Director
Help Seedlings Innovate Foundation Limited

[teslaalset]

Lawrence, thanks for you updates again.

At my side, my bicycle wheel has not arrived yet.
Also, its very hard to get hold of AWG 16 type of coperwire.
All I have is AWG 24 right now.