Stanley Meyer replication with low input power

[keithturtle]

My post presupposed voltage measurement, as wattage cain't be calculated without it.
Sorry I fergot to mention that.
Turtle

[ravzz]

Hi Stefan,

I do have an analogue DC Amp meter fixed in the Freq Gen. The digital meter I have was read on the range of 0 to 20A and the analogue shows almost the same but you can see that it keeps fluctuating with the pulse.....even thats at around 0.5A.

The voltage is straight DC from the AC to DC converter. Is there any thing else I might be missing?


http://www.youtube.com/watch?v=taFrw3xxDow



Hydro the LED on the left part of the circuit is placed before the switch and you can see that when the switch is turned off the right LED doesn't blink and the current draw increases by more than four fold! The right LED is on pin 3 of the second 555. I hope this clears what you had in mind Hydro.

Ravi

[nada]

f

[hartiberlin]

Looks good now.
So I see, that you are using a 12 Volt power supply to run the whole thing, right ?

Are you using just pulses in the Hz region not Khz range ?

Is your circuit the D14.PDF page 7 circuit
with 2 x 555 timers ?

What are the exact 2 frequencies ?
Can you show also the chokes in your video
or just open up your plastic box and have
a
longer look into it ?
Many thanks.

[ravzz]

Hi Everyone,

I've received a mail asking me to market the system....I would want to close this topic once and for all.....so im posting the reply to the mail.

---------------------------------------------------------------------------------------------------------------------------------------


Im free sourcing what i've done......all the circuits needed and the hardware that I used including the dimensions is on this thread and the thread at www.oupower.com

Trust me you wouldnt be allowed to market this unit....the world economy runs on fuel and energy taxation.....you cant put something into the market that is going to alter everything the way we know it.....it takes time for everything to evolve.....this is the future but if you can make it....make it for yourself. I've already been raided once for trying to experiment with this technology....and free sourcing is the only way out for this kind of technology.

I am already collaborating with Panacea-Bocaf to release some ideas where in this system can be used to augment non-conventional fuels (which have very low calorific values) in the power generation sector. This idea would basically curtail immediate job losses and would give time for the economies to evolve to the next generation fuels but eventually it would seep down to the grass roots level in a few decades.

I'm posting this mail on the thread so that everyone gets to know that I dont expect any commercial returns from this system.


---------------------------------------------------------------------------------------------------------------------------------------





This belongs to the world its free!! even if you cant completely run an engine on this it can give you increased fuel efficiencies to the range of 50%.....like it did to someone in one of the videos posted in this thread....the improvement is from 28 miles/gal to 45 miles/gal....this is an increase of almost 60% !!....I cant vouch for his claims....I havent tried this and I dont intend to aswell....

But please do post your results incase you try this system.....This would be the smallest gratitude that I expect for my effort.

Even if the efficiency improvement is 20 to 30% depending on the driving conditions.....it would be a huge favor we are doing to the world we live in....and we are saving that much percentage of pollution that our children and the future generations don't need to live with.


RAVI