Stanley Meyer replication with low input power

[ashtweth_nihilisti]

Okay i roger the wave form request and will put it on our cell when done .
BTW that Bedini thing i was talkng about, here is a failed solid state one we did, we know this isn't the right wave form as it was a modified Bedini solid state, still the gas production impressed us.
http://video.google.com/videoplay?docid=-8505608988059308396&hl=en

We will have a Bedini solid state with the magic wave form thats voltage potential only built in a few weeks. Need more hours in the day

What can Ravi use that pancake col for? surly there has to be some use those videos i posted look worthy of experimentation.

[ashtweth_nihilisti]

well i hate to say this,but where do you think iam from? 
i tried almost all possible waters that i can get.

Interesting, do we have detail of your set up on the board? our second cell has Ravzzz gap and will be annealed i think this is important but the lab will tell. Also did you use 9 inductors? plus how long did you condition for ?

Ash

[HeairBear]

The device shown in the picture I posted on page 22 of this thread is what Stan calls an EPG. The link is a video of him explaining it in New Zealand. Fast forward to 9:30 to cue it up.

http://video.google.com/videoplay?docid=1691076304149468256&ei=0-qfSOXLJoS64gK07cEc&q=stanley+mayer+new+zealand

[fever16]

i have 2 simple setups.
each one has 2 tubes only.
i machined nylon bobbins such that they sit straight till the top and soldered 2 copper wires(ofcourse covered those exposed terminal with synthetic glue to avid contamination)
so my tubes will be held at the bottom only.

regarding the conditioning i did it or more than 1 moth i guess (it does formed some layer) but when i start comparing it with DM water setup,i stopped it.this dm water setup does not formed any layer at all.(ofcourse no minerals)
so i want to concentrate more towards chokes,stepup transformer and resonance stuff.

[ashtweth_nihilisti]

Okay, please try a few things for me,

1) do a gas flow test with what you have now
2) add the VIC (inductor and toroid) and do a gas flow test.

next or do this before.,

1) do a gas flow test NOW
2) condition every day for next 4 weeks
3) do gas flow test to notice change

it takes an average of 3 months. Your results will still tell you more then you know now so please try this.

Ash