Stanley Meyer replication with low input power

[capacitor70]

and how long did it take you?

Actually I did it for only eight days. I don't have patience. then started work with plasma system

[ashtweth_nihilisti]

Guys unless you follow the replication instructions EXACTLY then how can you expect to get any results?
Ravzz doc is updated too.

Ash

[sbeehre]

ive been looking through the latest ravzz document and in there they are talking about using the cell as a booster to give you a 50% mileage increase... does this mean that its not capable of running a car? what i was wondering was if you had 2 or 4 cells working together would you use the same power as one but get 2 or 4 times the gas?

[professor]

Did you use Distilled water,Tapwater or any chemical additives?
What material are your tubes made of ? (316L Stainless?)
Thank you
Professor

I have a very even coating in one of my experimental tube cells, and the coating is so thick it pretty much fills the whole 1.5mm gap..  I got this by using low current (minimal bubbles), with straight DC electrolysis, for 3-5 hours .. Then let dry, or use a blow dryer, then repeat .. After about 2 weeks the coating is very thick.      And it looks like a crystal formation (symmetrical) at the bottom side of the cell.

Not sure if that will lead to the same results as Lawton/Ravi but it worked well for making a thick, tough, oxide coating.



HeairBear, Thanks.

[Jokker]

About shot that you took 

Nice waveform    where did u measured this signal ?