Overunity.com Archives is Temporarily on Read Mode Only!



Free Energy will change the World - Free Energy will stop Climate Change - Free Energy will give us hope
and we will not surrender until free energy will be enabled all over the world, to power planes, cars, ships and trains.
Free energy will help the poor to become independent of needing expensive fuels.
So all in all Free energy will bring far more peace to the world than any other invention has already brought to the world.
Those beautiful words were written by Stefan Hartmann/Owner/Admin at overunity.com
Unfortunately now, Stefan Hartmann is very ill and He needs our help
Stefan wanted that I have all these massive data to get it back online
even being as ill as Stefan is, he transferred all databases and folders
that without his help, this Forum Archives would have never been published here
so, please, as the Webmaster and Creator of these Archives, I am asking that you help him
by making a donation on the Paypal Button above.
You can visit us or register at my main site at:
Overunity Machines Forum



Selfrunning cold electricity circuit from Dr.Stiffler

Started by hartiberlin, October 11, 2007, 05:28:41 PM

Previous topic - Next topic

0 Members and 16 Guests are viewing this topic.

hartiberlin

Okay, now also at my place the Google video is showing,

One more information about it.

The scope in the video was always connected directly across the
signal generator output, so you always see just this output there.

Of course I had connected also the scope ground to the
signal generator ground.

So you see the damping of the output wavefrom from this
choke and LED load going into the stainless steel mesh via this one
wire setup.

I had the camera on a tripod, so it would be not so shaky,
but sometimes it was then hard to film the right parts of the table,
when I wanted to film the whole scene.

Will get better next time.
Regards, Stefan.
Stefan Hartmann, Moderator of the overunity.com forum

hartiberlin

@amigo

well done.

Try to put a ground cable or a big alufoil
or metal mesh against one pin of the LED
( does not matter which one)
then the LED will be much brighter at the right
resonance frequency.

Regards, Stefan.
Stefan Hartmann, Moderator of the overunity.com forum

amigo

@stefan

Thanks !

That's what I first tried, and it made it brighter, but I noticed I do not get any change now that I have the Al foil underneath it...

hartiberlin

I have problems measuring with my grounded scope now the current coming from
the signal generator at a shunt.

Have to isolate the scope from the ground first and then try again.

Stay tuned for this.

@amigo,
when is your LED the brightest ?
With the alufoil below your experimentation board ?

Or with the alufoil just connected to one LED pin ?

Can you try to measure how much current flows from your
driver circuit via the one wire to your ferrite transformer  ?

So the main problem is with these circuits,
how do you design a very low power very fast rising square wave
or pulse generator ?

Would be interesting to see, if shorter positive pulses will
still give the same brightness if you change the duty cycle.

Regards, Stefan.
Stefan Hartmann, Moderator of the overunity.com forum

amigo

I have made a video, especially for that paranoid delusional freak who's name I won't mention and his followers, but everyone is welcome to watch it...it's educational !

Video Link Here