Muller Dynamo

[khabe]

hi folks,
I was quiet few days as requested,
Perhaps some results or any good news?
cheers,
khabe


hello nul,
Now I did read all 118 pages,
and what I nowhere cant see is your replication,
I guess you spent not any cent, you bought even not sewing bobbins 
Are you just a supporter-talker
cheers,

PS:
Weekend again, what you doing in band, is it Bayan 
have nice jamboree

[woopy]

Hi all

The litze wire are probably trying to cross the Chanel by swimming. 10 days ordered and nothing in my box this day and we speak of progress yup !

So no time to wait and i was very surprised that i could wind my 18 coils in less than 2 hours with my lathe, I did not count the turns but i put so much wire as i could on the "Brother " sewing spool , and i was not so much surprised that all the coil are at about 5.5 ohm each. with my 0.3 mm copper wire-

OK this building is not very difficult to do but i have to say that a certain handaccuracy is needed. so to speak.

But CLANZER is at work and will probably do all this staff so easily with its CNC machine,

OK so far i will not make a video as Stephan asked me because there is simply nothing to film when the Biasing magnet are in repelling position. This does not mean that this config is not accurate, but if it is , i can not see it on the magnetic screan, so not filmable.

OK my progress today in pix

Good luck at all

Laurent

[khabe]

woopy,
you have very tiny repellent magnets
Or?
cheers,
khabe

[AbbaRue]

@Pirate88179
The link you gave is for Acrylic plastic. 
The sign company I worked for used Lexan because it will not shatter like Acrylic does. 
You can pound on it with a hammer and it just dents, but it does scratch a lot easier then Acrylic. 
We used it because kids can't smash it by throwing rocks at it like they can with other plastics. 
The fact that Lexan doesn't shatter is it's strongest point.
When it was delivered to us, it was always rolled up in a large roll. I don't think you could roll up Acrylic. 
If you look it up Acrylic's chemical name is Polymethyl methacrylate  and Lexan's chemical name is Polycarbonate.
They are totally different items. 
The following link gives more detail:
http://hemineko.net/wp/acrylic-plexiglas-vs-lexan/
If a piece flies off the motor and hits the Lexan there's a good chance it will become embedded in it, and not pass through.  In any case it is much safer then leaving the motor wide open, that is why I mentioned it.

[woopy]

Hi Kahbe

that is a very interesting notice, which is surely and certainly  very helfull at this point of the replication.

How big are your repellent magnet on your's

Bythe way .have you perhaps also a good definition of "trolling" ?

thanks

Laurent