Muller Dynamo

[tinu]

...
SO -- my question has to do with HOW to make rigorous MEASUREMENTS of a moto-gen (MG) combo.  Help me on this, I know how to do measurements of V and I using a Tek 3032 DPOscilloscope, for example.  Is that the best way to do rigorous measurements with an M-G?

Hi,

IMHO the best way to do measurements would be to reduce it to pure DC in and DC out. Use appropriate RC filters (big caps, rheostats where needed) to isolate the mot-gen setup or otherwise the “black-box” and measure pure DC input and output power. Calibration is incomparable easier&cheaper and errors may be set below an arbitrary small level; still, joule and EM radiative loses need to be properly accounted for but in comparative experiments which are set up conveniently, those can be eliminated altogether for a conclusive analysis regarding the “OU factor”.

If you have the patience to search through my former posts, I think you’ll find a more detailed discussion on the above. The subject was detailed by other members too.

Best regards,
Tinu

[JouleSeeker]

JouleSeeker   
Maybe it is really an Inside Source of Energy  (ISE)   with the spin of the electrons providing the energy of magnets in a timed varience reaction.    Consider.

Bill

OK -- this is possible also; EXPERIMENTS should provide the answer, once we get the device up and running so we can test for the source of the incoming energy.  Fun stuff!

@I-ron -- all I can say is -- I wish we could FIND this guy Rod Clark, so we could ask him about all this.  AND one of his devices for testing!  or at least the plans. 
I think he genuinely needed money in July 2008 when these vids were posted; I do not judge him a fraud at all, but await further data regarding his device and his whereabouts. 
Indeed, this is an interesting device IMO.  Very much like Muller, Watson, Romero, etc...

[Cap-Z-ro]

Quote iron:

" Not too likely Cap,

Quote:  "To make it Easy to Understand I am Giving this house to anyone who can get a Loan for the Balance left.

I have been Unemplyed for 14 months and my Unemployment is about to expire now that I am on my 3rd extention

My ARM on the house is due to ReNew  in June 2010 I no longer Qualify to live in my house without and actual income."

Ron "


Gee, I dunno Ron,

If I wanted to get away to the mountains on the QT with a free energy device, I probably run a very similar advert...you just never know.

Regards...

[maw2432]

Can someone help me understand the adjustments that can be made with the Romero  design?
Is there a way to adjust the driver coils separately?  vs. the pick-up coils.  This seems to be important to me. 

Bill

[Dave45]

Can someone help me understand the adjustments that can be made with the Romero  design?
Is there a way to adjust the driver coils separately?  vs. the pick-up coils.  This seems to be important to me. 

Bill

Romero said to run the motor from an outside source, not from the coils maybe a dc motor that you can control the rpm's with a belt run to the rotor, disconnect your coils from the fwbrs an tune to peak ac, tune each coil then reconnect, when you have tuned everything a hundred times the magic happens