Working Magnetic Motor on you tube??

[Omnibus]

I haven't read all the posts in this thread, but I have a question. Has anyone been able to reproduce his results? There are several similar devices on youtube but I haven't seen any of them work.

Not yet. We're working on this as we speak.

[Libra8]

I haven't read all the posts in this thread, but I have a question. Has anyone been able to reproduce his results? There are several similar devices on youtube but I haven't seen any of them work.

[Grimer]

Okay two tests one after the other 3 Stators, No AGW from 430RPM.

Thanks very much for the data. Interesting.

Quite a variation between tests. And there is some suggestion of a bump at about 350. Should there be?

Is that the AGW stator trying to kick in by not managing it?

On the evidence so far I doubt if stopping the GW rotors will show much.

It would appear that the dampers make very little difference.

[CLaNZeR]

I haven't read all the posts in this thread, but I have a question. Has anyone been able to reproduce his results? There are several similar devices on youtube but I haven't seen any of them work.

Sorry to say no one has re-produced the working effect yet.

But on the bright side, if it does not work, Hey atleast we tried

Then onto the next project 

[CLaNZeR]

Quite a variation between tests. And there is a suggestion of a bump at about 350. Should there be?
On the evidence so far I doubt if stopping the GW rotors will show much.

It would appear that the dampers make very little difference.

The 350 downward bump on the AGW run downs I would say is me trying to get the latch.

I would say the charts show that in AGW the Dampners make for a longer Wind Down.

When no AGW is attempted them the Dampners actually cause the Rotor to wind down quicker.