Working Magnetic Motor on you tube??

[Omnibus]

@All,

I'll go even further in my off-topic ramblings. Why not ask Stefan to make it a sticky thread and have a place where we would discuss and agree on what exact parts are to be ordered while waiting for Jason's drawings. Maybe @CLaNZeR as one of the savviest constructors would be willing to make a list of the concrete, say, magnets that are to be ordered to begin with. There still seems to be a bit of confusion about that. Also the bearings and whatever dampers etc. I'm preparing for ordering all this and I'd like to be sure it'll be the right one as much as possible, to avoid delays later.

P.S. I wonder if @tao already knows about this.

[Freezer]

Weee!     Another magnet motor setup to work on.  Looks promising, and simple.  I will give this a try and hope you guys good luck.   

[CLaNZeR]

Okay Base all done now:



Hope this makes sense now regards the top bar and the slots for altering the Stator/dampner positions.

[Omnibus]

@CLaNZeR, you're amazing. Keep on doing the good job, mate.

[CLaNZeR]

Would NOT say I am one of the Saviest contructors, you know me, I am like a Bull in China Shop LOL.

Regards the Dampners and Magnets, I just email Craigy and check with him 

I think the Stator magnets are pretty obvious and Craigy has supplied the link and the part number, I have ordered these but like everyone else have to wait for delivery from USA
The Rotor magnets should not be too bad as the design of the Rotor allows us to move the position and also change the config.

The reason I have gone for the Top bar is after building alot of Rotors, this is the best configuration to reduce your losses, but maybe with this configuration it is not needed as much, but playing safe this end.

Where is the other thread on this subject?

Cheers

Sean.

@All,

I'll go even further in my off-topic ramblings. Why not ask Stefan to make it a sticky thread and have a place where we would discuss and agree on what exact parts are to be ordered while waiting for Jason's drawings. Maybe @CLaNZeR as one of the savviest constructors would be willing to make a list of the concrete, say, magnets that are to be ordered to begin with. There still seems to be a bit of confusion about that. Also the bearings and whatever dampers etc. I'm preparing for ordering all this and I'd like to be sure it'll be the right one as much as possible, to avoid delays later.

P.S. I wonder if @tao already knows about this.