Working Magnetic Motor on you tube??

[Craigy]

The spdc is the steorn private developers group but the subject matter was the whip mag, which i suppose does not count as far as steorn are concerned. Still a 20 sec run is a little confirmation of what Sean has done and i can feel it in my rig. Just have to carry on playing

[oak]

The spdc is the steorn private developers group but the subject matter was the whip mag, which i suppose does not count as far as steorn are concerned. Still a 20 sec run is a little confirmation of what Sean has done and i can feel it in my rig. Just have to carry on playing

The actual statement posted in the SPDC is:

"it was running at almost constant speed for 20 seconds, but it did not manage to gain speed, and then it slowed down a little bit, and then it ran down as normal.  So my hope is to make it sync at a little higher speed and start to gain speed."
---------------------

I wanted to clarify precisely what the SPDC member said, because to me saying "almost constant speed" is not the same as saying "constant speed."

(Originally in this post, I identified the SPDC member who posted the remark, believing he would not mind.  I don't know whether he would mind, but in retrospect I realize I was out of place to do it, so I've removed his name.)

[Grimer]

The spdc is the steorn private developers group but the subject matter was the whip mag, which i suppose does not count as far as steorn are concerned. Still a 20 sec run is a little confirmation of what Sean has done and i can feel it in my rig. Just have to carry on playing

To avoid confusion over which Sean you are talking about and subsequent wild rumours it would be best to call this Sean, CLaNZer or the other Sean, McCarthy.

Also, SPDC stands for Steorn Private Developer's Club, not group. It is colloquially know as the SPUD which is a lot easier to say and to remember.

[Craigy]

There is a virtual circumference ratio, by virtual i mean that the radius is extended with the airgap size. that distance is used to calculate the virtual circumference, then the stator circumference should be as close a match to the ratio 4 to 1, with that in mind i belive i need 12mm stator , and not the 15mm stators i made up out of 2 neos and plastic, think i might make 4 or 5 sets of stators with each one with a different diameter, from 10 mm up to 15 to get some thing nailed down

[CLaNZeR]

To avoid confusion over which Sean you are talking about and subsequent wild rumours it would be best to call this Sean, CLaNZer or the other Sean, McCarthy.

Nope dun't agree

I have always signed Cheers Sean in these forums and it was only in the SPDC that I had to use SeanH because people were getting confused LOL 

Now I am a EX member of the SPDC like you Grimer , I do not think their rules apply in here.

Cheers

SEAN.