Working Magnetic Motor on you tube??

[Omnibus]

@ken_nyus,

You may have a point. I've noticed difference in behavior and probably easier appearance of the effect when more than one stators are forced AGW.

Just to be clear, with equal spacing of rotors?

like at the 1/2 or 1/4 points.

Don't quite understand what you're asking. All stators are at 5mm distance form the rotor. Is that an answet to what you asked?

[hoptoad]

Please allow me to have some doubt in what Bill writes in his posts.

@Shirakawa
You don't need anybody's permission to doubt anything that anybody says or claims.
Cheers all. Hope you find what you think you are looking for.

[rice]

hey Omnibus, did not you say that you have built a working model and it accelerates.  lets see a vid or pic.  i am indeed interested to see it

[Omnibus]

hey Omnibus, did not you say that you have built a working model and it accelerates.  lets see a vid or pic.  i am indeed interested to see it

Go back and read what I've said on the subject.

[MeggerMan]

Hi Bill,
Yes I remember you from the Joe Cell days too and I have no problem with you reporting on your results - in fact I still have 3 joe cells in the garage, I noticed some very odd effects with the tests that I carried out.

Anyway, when you had the 1 minute sustained run, were you able to monitor the RPMs ?

From the video you posted earlier it is very apparent that a hand spin of the rotor soon slows to a stop in 15-20 seconds so a sustained run of 1 minute is a big step forward.

@DA,
I have made your suggestion about angled stators to Al, I too had this idea a few pages back.

@Bruce,
Regarding the N35 magnets, I got Al to measure the vertical repulsion distance between two rotor magnets, 1/4" dia x 1/2" rod and he measured it to be 30.5mm which is about what I got with the ones I ordered from S&J magnetics at 31.5mm, if someone has some N38 or N35 rods they could perhaps do the same test and feed back the results.

Regards
Rob