Tri-Force Magnets - Finally shown to be OU?

[FreeEnergy]

i can still return it

guess i'll do that tomorrow

[AquariuZ]

@ClaNZeR et al

What I have been trying to tell you guys is that YOU DO NOT NEED to pair the gate in a left right or up down configuration. The roller will move past a single row of triangles!

There is no repellent force when u use single rows of triangles.


On a single line I have placed six triangles (not interconnected with a fourth bar) in NNS config and six triangles in a SSN config on the SAME line.

Now take a roller (magnet with two steel balls) place it in the beginning of the line, and you will see a fierce acceleration to the right (provided you have S down). Decelleration at triangle 7 or 8, complete stop well past triangle 12. Comes back and swiftly accelerates past 12, 11, 10 , 9 , 8 & 7 and starts slowing when nearing 6, 5. Then comes to a complete stop near triangle 1, and swiftly accelerates again in direction of 12 and does so for about 4 minutes...

You do not need to run the roller between two triangles, it will pass a single triangle with less resistance and very fast so.

I wish I had a camera, 

[Omnibus]

@AqyariuZ,

Can't you use one of these cheap  $5- $6 web cameras ( http://www.geeks.com/products.asp?cat=VID ), use your cellphone or borrow from a friend or a neighbor? It's interesting to see what you've done.

[Lakes]

@AquariuZ, no webcam or cameraphone?, flatbed scanner? 

[Omnibus]

@AquariuZ, no webcam or cameraphone?, flatbed scanner? 

Now, flatbed scanner to produce a video is a wee bit stretching it but what do I know ...