Meyer-Mace Isotopic NMR Generator

[verpies]

@T-1000
Wasn't your U-shaped copper tape looped over point B ?
Different shape of the winding affects the field shape near its end, doesn't it?

[Osiakosia]

@T-1000
Wasn't your U-shaped copper tape looped over point B ?
Different shape of the winding affects the field shape near its end, doesn't it?

Two  coper plates are connected  over the top of the core ( point A ) .
I did not connected its over pot B , couse in this situation I will not be able to
firmly attach second part of core with bifiliar winding .
I think I will try to connect this two plates by the thin copper strip ( over point B ) . Will see any difference .
P.S In yoke video the two parts of aluminium plates were simply connected by one piece of wire .

Regards

[Osiakosia]

What about the 15turn winding ?
As far as I remeber, STAAAR's team Yoke device had 3 windings (including the U-shaped turn).

I make photo after removing 15 turns winding .

Regards

[verpies]

I made the photo after removing 15 turns winding .

I asked because you did not mention applying any waveforms to the 15T winding - not because of the photo.
Aren't you driving the 15T winding at all?

[Osiakosia]

I asked because you did not mention applying any waveforms to the 15T winding - not because of the photo.
Aren't you driving the 15T winding at all?

Not yet . unfortunately . 
At first I want to catch this 6 KW output like in yoke device video . But unsuccessfully . But there is on hope .
The resonant frequencys of my device are aproximately the same .
In the begining of next week I wil receive new DCO and will try to apply all frequencies to device - 50 hz to
15 turn , 312 khz to 50 turn and capacitors to U-shape turn for obtain ferrite core resonance frequency .

Regards