Stubblefield coils (bifilar) and speculations

[Michelinho]

Hi Jenna,

"Coup d'oeil" is to have a look at.

If you go to the forum on TPU, I have layed out the theory adapted to the TPU and some clear thoughts on the inner workings and assembly. There are a bunch of Super brainy guys that I hope will help me make sense of my chain of thought.

That is nice about the brittleness of the iron. I still don't know why that would happen as it is not suppose to, according to the usual knowledge.

The conditioning of the coil and my present understanding:

The coil is exactly as Stubblefield shows it.

The control and conditioning coil is on the cell and feed with a source that will enveloppe the bifilar coil in a magnetic field or great itensity. I know believe the highest field the better. A rough guide would be to see how Tesla would have done it. With high voltage possibly to help the iron oxide particles migrate. Crystal latices grow in the small voids inside the rows as the effect of layers of identicaly charged wires will repulse and keep the crystal latices from groing out and shorting between rows.


Once the voids are filled the iron oxide latices grown under high magnetic field show supra paramagnetic properties or so I pretend in the Stubblefield cell. A research in MRI tech says the properties are known and in use today.

The project looks very good and I am flabbergaster at the sight of all I have written on it.

Take care Jenna,

Michel

[tak22]

Hello all,

I don't think I've posted here before, but I have been following with interest. Here's an article from Dave L that I don't think has been posted here before (I did a search for it) and looks relevant. Please gleam what you can from it.

http://magnetism.otc.co.nz/EarthNodes.htm

tak

[Michelinho]

Thanks Tak22.

I am familiar with Earth nodes or mini magnetic poles as some old guard thinkers refer to. Those are small magnetic vortices  that forms at the cross section of  the magnetic field lines. That too is part of the Electric Universe as on the Thunderbolt site. http://www.thunderbolt.com/

Leedskalnin used this concept in is work by levitating rocks inside those vortices created at the node he selected in Florida.

The game is afoot.

Take care,

Michel

[Michelinho]

Hi all,

Back for a session of brainstorming with my son-in-law. He's brilliant.

We have found an easy way to make a Stubblefield cell and no it doesn't need the ground. It can also be used for a TPU.

All you need is a tape measure the length you want.

Copper tape or awg 12 wire flattened with a hammer and an anvil.

Make a nice coil with cotton between each so as cotton is the isolator and electrolyte transport.

The inside end is left open inside but insulated. 10Fe and 10Cu.

Felt washer than another stack for as many as you want.

Connect the outside wires in parallel. 5Fe and 5Cu

Wet and use. A TPU  core is wound as an air core It even supplies energy.


A high efficiency Stubblefield cell or TPU core that you can stack for more energy.


Have fun,

Michel


I have copper tape from my old time with Tiffany lamps and a small 1/4"6 ft long promo measuring tape. Gift from a radiator shop.

A high efficiency Stubblefield cell that you can stack for more energy.

EDIT:  You can also make individual coils of iron and copper in a thin mold with a strip of cotton and blue the coil with one line of crazy glue and stack iron/copper/iron/... Connect the outside open end in parallel copper with copper, iron with iron.

[Pirate88179]

These ideas are great!  I can't wait to see your results from experiments.  I have always said that we, as in modern society, have available much more than Stubblefield or Tesla had at that time.  We should be able to do better than they did.  This will be fun.

Bill