Is Lindsay?s ?SM? a fraud?

[Spider]

Hi All,

I ripped the yoke out of my tv too, my little contribution to the forum


@otto,

The image resizer from microsoft works very good for me.
After install you get a new feature when you rightclick a picture, "resize image"

Link:
http://download.microsoft.com/download/whistler/Install/2/WXP/EN-US/ImageResizerPowertoySetup.exe


Greetings Rene

[otto]

Hello all,

@Spider

In the download section is my schematic with no title.

Otto

[otto]

Hello all,

the reason for bifilar coils - not as in Tesla patents but for driving the TPU in 2 directions - a little bit out of phase.

How to do it?

"easy"!!!

1 end of each control coil must be connected to an iron wire so our particles in the wire cant reach the collector in the same time. This is then the delay.

Otto

[otto]

Hello all,

nice and quite, fine. Remembers me on the time with my ECD, ha,ha.

2. try

I removed all my wires and collectors, yesterday.
Then I used 2 cores, placed as a circel. Inside a 5 turn lamp wire, horizontal.
Over the core and the lamp wire a 24 turns bifilar copper wire, in vertical, 0,5mm diameter.

If correct connected, a very nice lighted bulb and a vibration at 2ookHz. Only at this frequency the vibration. Fact is that I have builded a TPU with only 1 controls and 1 collector.

Yesterday, I was wrong!!!! Bifilar, 1 trigger coil, 1 load coil. The trigger coil a little bit out of phase. Just a little bit.

Im on vacation the next week.

Otto

If somebody plays with the yoke cores, building a TPU, it can easily kill you.

[otto]

Hello all,

3. try

4 turns of lamp wire as collector, CW
12 + 12 turns of lamp wire as control, CW
2 cores placed as a circle

signals of over 1000V on the output.

Very important - the gap between the 2 cores.

I have connected 2 100W bulbs.

Otto

PS: still on vacation.