AB Hammer design wheel for CLaNZeR to build

[AB Hammer]

greetings all,
I am using public computer for my DSL modem is being replaced and should be back by Thursday.

[helmut]

greetings all,
I am using public computer for my DSL modem is being replaced and should be back by Thursday.

Good luck with your modem.

The wheel is a interesting concept.
Do you have any experience in practice?

helmut

[gurangax]

any updates?

[CLaNZeR]

any updates?

Sorry to say not from me at the moment.

I need a clear run on this one of a couple of days to weld up pieces etc etc
Cannot do that at the moment as shooting off here and there doing stuff.

When back in a routine will crack on and have a go.

If only you could get paid for playing with this stuff, would make life and time more easy, but got to put food in the mouths other ways hehe

Cheers

Sean.

[Bulbz]

I have noticed one thing with a lot of these Gravity Wheel designs... The parts that do the pushing, nearly always seem to be near the outer edge, or or somewhere between the halfway and outer edge.

It is harder to stop a wheel from turning if you try to grab it at the axle, and that is why I have been trying to conceptualise a design that has all of the pushing parts, as near to the axle as I can get.

Keep up the good work guys.