permanent magnet motor suggestions

[mike-ao]

hi folks;

did anyone tried allready this kind of assembly?

I've made just a drawing for a V-Gate rotor as shown in several YouTube-vid's. with some add-on to think about. This kind of thinking I had allready end of the 70'ties, but I gave up, because

• the magnets I had this time was too weak to fool around with.
• not enought money to invest
• too young @ this time (whatever younth are doing....)

partial view of the rotor:
Side-View

Top-View

the orange "L-Coils" should generate some electric energy when they will be affected by the statormagnet during the rotation. this energy should by stored in a capacitor like this principe drawing


as soon the rotor comes close to the sticky point (center of P-Coil), the switch (transistor?) should unload the capacitor trough the P-Coil to generate a opposite magnetic field on the rotor-magnets. hopefully this should "weaken" the sticky-point strength.

my suggestion is to have a thin wire with many windings around the L-Coils and thicker, less windings on the P-Coil.

I've not the equipment and the knowledge to create coils as shown here.

regards mike