Joule Thief

[xee2]

@ Yucca

Here is your circuit drawn as typical Joule thief but with your resistor biasing. I think this is correct.

[nievesoliveras]

@ Yucca

Here is your circuit drawn as typical Joule thief but with your resistor biasing. I think this is correct.

Thank you @xee2. We only need now @yucca's approval of your schematic.
You are fast drawing schematics!

Jesus

[jeanna]

"...The earth currents seem to oscillate at a rate of about 2.25 to 2.50Mhz.... "


      Jeanna check out those current oscillations to make sure they are coming from the Earth and not an fm transmitter leaking into your detectors.  Great discovery if they are the real deal.  Great work here in the JT thread by all.  Wish I had a lab and some time to help out.

Sparks,
Please take a look at the video I posted on youtube, yesterday.

http://www.youtube.com/watch?v=xfwMFrqGtaE


It is a slide show of stills I made from highest resolution screen to the lowest on my scope.
In it I was using the plain earth battery with 2 additional non-alike Stubblefield coils added to each end.
The voltage with the Stubblefield coils is 30-40mV higher than with the plain Copper+zinc- probes in the ground.
(I made a technical error and was not able to add those comparable pics using the plain battery, but I can tell you the waves are similar and much lower. There is undulation but the amplitude is not as high.)

I am seeing fractals of these waves. To me that is a nice hint that they are natural. Someone told me that the fm transmitters were in the micro volt range so the milli volts are probably not from a radio transmitter.

But, I do not know how to tell other than to assume the buried nail and copper pipe are not going to pick up a radio and since the waves are the same only less strong voltage, they must be from the same source... the ground, or very near the ground. (I hope)

I watched the video of Meyl showing the scalar waves which he showed to be in the 7+Mhz level.
I might be seeing that, but not with this scope. The fastest wave I have seen to date, was 5.5 Mhz.
I hope to be seeing that again...
More coming.

I better go out and do that now.

thank you, sparks.
I appreciate your comments,

jeanna

[innovation_station]

JESUS AND YUCCA THOSE ARE WHAT I NEED FOR A GAP   

BUT THE CARBON SEAMS TO DO QUITE WELL MAYBE I CAN SOME HOW MAKE 1 OF CARBON ...

BUT IM THINKING THE EARTH BATTERY ...  AS MANY AS I NEED A TPU RING ... AND NEO ZAP

I HAVE THIS WHOLE SYSTEM FIGURED IN MY MIND JUST NOT IN FRONT OF ME YET ...

NO WORRIES IM ON IT LOL

COULD EVEN GO SO FAR AS MECHANICIAL SWITCHING DRIVEN BY WIND ... TO STOP FROM BURNING OUT SPARK GAPS ... 

PLUS I BET IT IS SPEWING OUT ENGERY EVERY WHERE I NEVER TRYED A CFL OR A NEON YET TO SEE IF THEY LITE WIRELESSLY ..  BUT IF YOU HAD MANY COILS ...  AND GAPS YOU COULD ROTATE THE NEO ZAP SO YOU STILL GET LOTS OF OUTPUT WITH OUT HEAT ... 

I DUGG OUT MY SG 36 COIL  ...     AND I GOT LOTS OF CARBON RODS... LOL AND NEOS TOO 

IST!

SG 36 NEO RING =   RING OF FIRE .... 

I HOPE TO ASSEMBLE SOME OF IT TONIGHT

[Mk1]

@ist

Those rods under water would make a nice hho generator ...