SPIRAL MAGNET MOTOR IDEA??

[sushimoto]

Hi again,
As i mentioned in your other thread,
i believe that most PMM-setups should use a flywheel
to store some momentum while accellerating.
This could help getting over sticky-points and friction.
In this video of a wankel-like configuration, the
"Driver-Disk" should be much more solid and heavier...
And in general it, needs less friction at the bearings and
the transmission to the s.c. Follow-Disk..

best,
sushi

And BTW: Your drawing does not reflect the video correctly.

[magnetman12003]

Hi again,
As i mentioned in your other thread,
i believe that most PMM-setups should use a flywheel
to store some momentum while accellerating.
This could help getting over sticky-points and friction.
In this video of a wankel-like configuration, the
"Driver-Disk" should be much more solid and heavier...
And in general it, needs less friction at the bearings and
the transmission to the s.c. Follow-Disk..

best,
sushi

And BTW: Your drawing does not reflect the video correctly.

Hi You are right about the flywheel. I plan to use a heavy flywheel should I attempt to construct this device

I already pointed out the crank arm will not work as shown in my crude illustration..

[magnetman12003]

Hi All,

Does anyone know where a flexible plastic ribbon type strip or roll ?? of gear teeth can be purchased?

If that gear tooth strip was wide and had self stick adhesive on the backside of the gear teeth it could be cut, wrapped, and secured around any wood disks outer circumference.

Two wood disks could be fitted with this plastic geared strip and used as temporarily as gears

Is there any known source for that and if so where can it be purchased?

[pese]

Hi All,

Does anyone know where a flexible plastic ribbon type strip or roll ?? of gear teeth can be purchased?

If that gear tooth strip was wide and had self stick adhesive on the backside of the gear teeth it could be cut, wrapped, and secured around any wood disks outer circumference.

Two wood disks could be fitted with this plastic geared strip and used as temporarily as gears

Is there any known source for that and if so where can it be purchased?

take it out from als frigidaires.
it sit in the closing door rubbers.
you will cut this on (knife) and you can treck out
thsis bands.
approx 10 to 4mm  up to over 1meter long

i use this sienc years to hold notices on some metal-devices
g.pese


i find this NOW also (first time) to buy now.
approx 2 euros for an (i belive) an half meter long
in an sur-plus-discount.

[X00013]

For best results of a one way system is to use a one way bearing instead of a rachet device. check ur local hobby store for clutch bearings on rc cars. be warned  the shaft must be percise, this is a link to  Traxxas bearings that need a shaft of 6.125 mm. ( very affordable ) the shaft you can you can get from metric hardware and any good hardware store, good luck.

http://shop.ebay.com/items/_W0QQ_nkwZtraxxasQ20clutchQ20bearingQQ_armrsZ1QQ_fromZR40QQ_mdoZ