Howard Johnson Replication Tube Claim

[wattsup]

@steve_chow

Pretty impressive set-up you have there. Both the HJ drum and also the RV we discussed on another thread. I hope @Ash got back to you on that but if not, let us know in that thread. Damn nice work. I think we all have loads (no pun intended) of stuff lying around from all our trials (and tribulations). lol

[Omnibus]

@X00013,

for builders

Great job, mate. Carry on. I'll be following your replication with great expectation and hope.

[PaulLowrance]

In his last video he describes his next video, which sounds better. I hope the next video is as described, with the camera far back showing everything, and very important that he also show the upper area of the top Aluminum bar where the stator PM is glued because there could be something inside that.

If it's legit, then maybe he has something similar to what Steorn was going to demo.

PL

Mylow, I would like to add to the above that a *lot* of people have been asking you to take a long uncut video of your machine to show that it does not slow down. Could you *please* do that, at least 9 minutes. I think Google Video allows a lot longer videos in case you want to really impress all of us by showing an even longer uncut video.

Thanks!
PL

[steve_chow]

@wattsup

I have been working on Free energy for last six years but so far no luck.......I will keep try..... ....


HJ - First I will try to install disk magnet on my rotor as same pattern as Mr. Mylow if does not work then will buy same magnet as Mr. Mylow.
RV- so far no response from Mr. Ash,  but I will try with three phase transformer to charge battery...
As you know, My Alt current output voltage is 206 volts at ~14 amps.
I am also try to built transformer from Tesla patter # 390721 which I can use With RV alt. output...

regards

Chow



 

[chrisC]

Mylow, I would like to add to the above that a *lot* of people have been asking you to take a long uncut video of your machine to show that it does not slow down. Could you *please* do that, at least 9 minutes. I think Google Video allows a lot longer videos in case you want to really impress all of us by showing an even longer uncut video.

Thanks!
PL

@PaulLowrance

It seemed like you write a lot but you don't listen well. If you watch his last video, he specifically said he bought this really nice tripod and will do the complete pan out of a video showing the complete start-up process with his hands out of the way, so everyone can see he's not farting to move the disc! He also did mention the disc WILL slow down because the iron core demagnetize over time! Do you understand what he said or you want to believe what you wish to believe?

cheers
chrisC