Howard Johnson Replication Tube Claim

[lostcauses10x]

the compass vidio is up.

[Omnibus]

Next thing is to see how these poles are positioned in the clusters of three and that lone cluster of four. Do you think you can ask him that or it will come out naturally?

@X00013, ALNICO magnets from page 7 of http://www.arnoldmagnetics.com/products/alnico/pdf/sacatrev.pdf will be just fine for the rotor, don't you think? I thought earlier we understood that the poles of the tips were the same. They are not, obviously.

[X00013]

Hans is in the house!!,   ok, checked out the vids, they are typical c mags ( MM), i will order and copy this build asap. And if MYLOW is reading this forum, thanks, i know where u live, just kidding, as far as i am concerned, if i can dupe this before the poloticians of pewski get wind of it the better. My options were A. spend $150 to see MYLOWS build, which didn't happen, or B spend $500 on a puzzle, Or C give the wife $500 and spend time shopping with her. I choose D, and i will post it, thanks again MYLOW (if it works)

[X00013]

@ omni, at this point, we have the dia of the disk, the mag layout, the problem is just what u said, MYLOW placed X amount of cmags on disk, we need to confirm there N?S pole position on the entire disk,

[lostcauses10x]

Expected.

Next thing is to see how these poles are positioned in the clusters of three and that lone cluster of four. Do you think you can ask him that or it will come out naturally?

@X00013, ALNICO magnets from page 7 of http://www.arnoldmagnetics.com/products/alnico/pdf/sacatrev.pdf will be just fine for the rotor, don't you think? I thought earlier we understood that the poles of the tips were the same. They are not, obviously.