Howard Johnson Replication Tube Claim

[joe_1001101]

Multiple systems were shown, yes.  But only the first one showed continuous rotation.

Yes, but the second one (radio shack magnet version) was reported to run too.  Not only run, but also spin too fast which caused the whole rotor to wobble enough that he had to stop it.

If we are going to take his video's as proof, we have to take his word too right?   So, they either both ran or both did not.

Joe

[fleubis]

Yes, but the second one (radio shack magnet version) was reported to run too.  Not only run, but also spin too fast which caused the whole rotor to wobble enough that he had to stop it.

If we are going to take his video's as proof, we have to take his word too right?   So, they either both ran or both did not.

Joe

Mylow didn't say it ran continuously.  If the magnet's flew off then clearly it didn't run continuously.  One partial rotation of powerful magnets could easily dislodge those super-glued magnets. We don't know about this and all these extrapolations aren't very productive. We are probably better served by studying the videos we have and what Mylow actually said.

[queue]

I know everyone would rather see a working replication .. heres my truth ..

In the last movie i showed the transaction 8 rotor .. which seemed to work really well
http://www.youtube.com/watch?v=aQXemB57F38

Now i have continued that disk all the way around ..
Same symmetry as on Mylows last working disk video where he uses 7*7 + 1*6
On this disk i have 7*8 rotors + 1 *7rotors

No it doesn't work - the video is uploading to Youtube .. .

Now i will be knocking off on from each 8 and one from the seven set and trying again.
Once i have completed that change the disk will be the same as Mylows last video ..
i have the same stator he was using in that last video..  so with my disks symmetry also the same .. well
one can hope..

So far no Mylow effect ..

[joe_1001101]

Mylow didn't say it ran continuously.  If the magnet's flew off then clearly it didn't run continuously.  One partial rotation of powerful magnets could easily dislodge those super-glued magnets. We don't know about this and all these extrapolations aren't very productive. We are probably better served by studying the videos we have and what Mylow actually said.

Extrapolations??  Not here.

This is what Mylow actually said about his radio shack bar magnet rotor, message 490 from mylow_magma group:

"he said that they do turn full rotation and continue spinning,
but he stops it because as it goes faster it begins to wobble too much. He said
the bar magnets go all the way around on that one, with no sets with gaps
between the sets."

[nyctuber]

Watching the last video Mylow made, he says he tried many combinations, but Queue's and Clanzer's were not tried. He never used the rotors both Queue and Clanzer have, and although he used the stator Queue uses, he did it with his old rotors.

According to the video, he got it to work with what are now easily obtainable magnets but which no one has tried. The large black squareback  horrseshoe Sterling sent (forget the part number) and regular Radio Shack bar magnets. So, perhaps someone should try this.

If someone tries that and it doesn't work, it's obviously a fraud.

EDIT: Forget all that, I changed my mind. Mylow is a con man, I'm done with this energy drain. Good luck!