MylowHJ Replication - Discussion

[TinselKoala]

What's that near the table leg that can be seen at 7:51 - 7:53 in his latest "last" video ??
Why the brown cardboard or placemat? It wasn't there before, in the non-running glass table vid.
See how light that stator mount assembly is. How is it pushing the wheel, without itself being pushed?
Once again, either the stators are NOT providing the pushing torque, OR the device violates Conservation of Momentum, and is hence the most momentous discovery since the chronometer.

[chrisbis36@yahoo.com]

Hi all.

I just watched withgreat care and attention- Magnetmotor1 (MyLow)'s latest vid.
I think its a superb vid and id like to share this observation-
1. Yes Defo 2 stators, slightly appart and offset by approx half the width of one of the stators.
2. he articulates that stators are approx 2.5" gapping away from the surface of the rotor magnets upper most surfaces.
3. the rig on initial start-up, seems to take ages to begin accelerate, and it looks like the rig(platter as he calls it) seems to energise before it can attain an acceleration force;- for accelerate it does.
4. my best guess on max speed attained before he stops it- 75-80 rpm.
5. from last (previous to latest vid), there are wear marks on base of the centre bearing support that look like rub marks from the outer race of his single bearing device- i note it's shielded with some sort of elastopolymer dust/grease cover. if its dragging, y, and is it deliberate or an oversight? it could go even faster unless that drag is its vertical mass support and it has to bear on something since the bearing shown has not shoulder to sit the rig(platter) onto.
6. it was easier to stop than he made out.
7. the spacing gap between the sets of rotor magnets line-out on the alu platter, i think give time to phase loop and repulsing field and maybe producing some variant  of induction.

Any thoughts u guys/gals?

Chris(newbie)

[chrisbis36@yahoo.com]

Why the brown cardboard or placemat? It wasn't there before, in the non-running glass table vid.
A. he says to stop the stator arm/mount from slipping.


Conservation of Momentum, and is hence the most momentous discovery since the chronometer.
[/quote]

Could be Al. Hope so eh. Worth 1200 of anyone's dolla.

U could replicate this one without a motor, with proper bearing, poss a linear bearing, no/yes?

It could be a 'Runner' as we say inthe trade!

[chrisbis36@yahoo.com]

Mylow (Magnetmotor1) indicates that the stator(s) are being pulled down onto the rig(platter)

How could that be if the device is acting in a repulsive mode unless the early stages of rotation somehow energise the whole device prior to its acceleration phase?

I know the acceleration is really low down on the scale of things, but there is no dout is does acccel.

[TinselKoala]

Only now, there is danger of the stator mount slipping? But not before?

Once again, what's that near the table leg at 7:51 - 7:53 ??

Want to bet this video disappears soon?

Yes, I could still reproduce what's been shown. Especially if I am allowed to use a placemat, carpets, glass tables with big crossbeams. But they aren't strictly necessary.